Respectfully, I must disagree AlterEagle- (unless you're only speaking to using a #1 vs a #2 on the supporting structure of a deck) We treat both #1 and #2 Southern Yellow Pine at my plant. Since SYP makes up most of the pressure-treated lumber that's produced in the US, it's a good bet that BrianZ will be using SYP. That said, there is a distinct visual difference between the two, as well as a slight structural difference. There are less wane and knots allowed per SPIB grading rules in a #1 than there is in a #2. That alone is a big difference visually. #1 material is generally slightly stronger than #2, but I don't see any reason to go wild and use #1 material on the joists and ledger board on the deck. Additionally, your posts are generally going to be #2 if they are 6x6's, as #1 is very difficult to come by in SYP timbers. Decking will be either PREM or STD, Premium being the equivalent of a #1, and STD a #2. I'm not a big fan of using 2x6 as decking. I'd rather go with a 5/4x6 radiused edge decking. And if it was my deck, I'd use premium decking. It's just a lot better than the standard. I hope this helps Brian...
[This message has been edited by JayF (edited June 29, 2003).] |
Member Since
11/20/2002
Total Contributions
59 Posts
|
Moderated by Mark Hammond 
