This is late.. but if it comes up again, or anything similar for that matter. This is a simple matter of bisecting the angle, but you have to make the real world math match the miter saw table, (I show you that on the crown site too).
There is a tool all of us carpenters should have in their tool box and that is the prosite protractor, you can see it and how I use it on my how to install crown molding site plus I put some stuff up on amazon about it too.
That protractor table matches the miter saw table which is the beauty of it, it was invented by a carpenter just like us too... I put a little article about him on the site.
Hey, use the link from my site though if you pick it up at Amazon, I use the extra pennies to keep that site running. ;)
Alter Eagle Construction & Design
http://www.altereagle.com/ | Construction & Design | http://decks-ca.com/ | Decks, California outdoor living | http://kingofcrown.com/ | Molding and finishing | http://installcrown.com/ | Crown tutorial
|
Member Since
12/28/2002
Total Contributions
540 Posts
|
Moderated by Mark Hammond 
