could be.. I use one of the newer Dewalt angle finish nailers and the guys that work for me use my Senco sfn 40's...I use the 16 gauge angled generic nails that are sold at L@we's by Fasteners Unlimited. I believe the genuine Senco finish nail is a 15 gauge but they cost twice as much as the 16 gauge generic which work just as well as the genuine Senco nail. I go through about 25,000 finish nails a week (not including brad nails) and only get an occasional jam which is ALWAYS caused by hitting a drywall screw or plate in the wall under the trim.
However even the 18 gauge brads will split wood if the nail head is shot in across the grain. [This message has been edited by Cornerstone (edited March 31, 2003).] |
Member Since
03/30/2003
Total Contributions
9 Posts
|
Moderated by Mark Hammond 
