On your model belt sander, all you do is push the front roller against a solid surface. The roller will lock in place. Change belt and then use a large screw driver and pry just below the name plate. This will snap the roller back in place. You may have to track belt. This is done by turning large screw on the side of sander. Hope this helps. By the way, I am looking for a used one just like yours for parts. I broke a gear and they do not make the part anymore. If you know where I can find one you can email me at denniscindyfoley@yahoo.com |
Member Since
06/03/2006
Total Contributions
2 Posts
|
Moderated by Handyman 
