This is getting to be a problem. Just replaced motor in a Kenmore dryer. Upon reassembly, when I turn it on it is sounding like it is rubbing on somthing and upon each rotation make a clunk sound.

I have repaired quite a few similar dryers in the past from motors to coils to belts, thermostats etc. and have never encountered this problem.

Took this thing apart 2 more times to recheck proper belt routing, rollers, tensioner, heck even for proper motor rotation and it still makes this noise.

What could I be overlooking !!

On most models of Kenmore dryers, the thumping could be caused by a flat on one (or more) of the drum rollers. The rubbing could possibly be the rear drum seal rubbing on a ridge on the bulkhead. You can read about installation of that seal at the following link:

LINK > Rear dryer drum seal installation instructions

I can't think of anything else, sorry.

Dan O.
www.Appliance411.com
The Appliance Information Site

=Ð~~~~~~

BTW. What was the trouble with getting the motor out?

Dan O.

The blower was froze on the back end of the motor.

It almost took an act of congress to release it.

C.

Try checkeing the 2 piece nylon or plastic bearing on fromt of drum. Most large mouth dryers have a 2 piece bearing. If any of the mounting tabs are broken, could be the problem