|
Powr-Kraft radial arm saw, model TPC2610A |
10/10/2008 09:21 PM |
kcfred |
NEED TRIGGER SWITCH (power switch). Where can I find parts for this saw? |
Member Since
10/10/2008
Total Contributions
2 Posts
|
| Post Reply | Watch this Topic |
Trigger Switch Power-Kraft |
12/27/2008 12:20 PM |
Mullet |
Hello KCFred,
I migfht have a spare switch for the Power-Kraft TPC2610A.
We needed one a while back and my father-inlaw found a place in Dallas where they had a switch that worked, he purchased 2 of them. I will have to look out in my shop to see if I can find the switch. I Also have the manual if you need a page or two faxed or emailed to you.
The problem I seem to have is how to grease the gears without taking the whole motor assembly apart.
Mullet |
Member Since
12/27/2008
Total Contributions
3 Posts
|
| Post Reply | Watch this Topic |
Switch |
01/30/2009 04:29 PM |
mk26loot |
We also need a power switch for the same Radial arm saw. Did you find a place to buy a new one?
If so would you please send me the address to get one.
mk26loot@peoplepc.com
Thanks Jim |
Member Since
01/30/2009
Total Contributions
1 Posts
|
| Post Reply | Watch this Topic |
2610a |
02/24/2009 03:40 PM |
fow111 |
are bearings available for this saw?
If so what is the best way to dismantle?
Pete |
Member Since
02/24/2009
Total Contributions
1 Posts
|
| Post Reply | Watch this Topic |
Parts |
02/24/2009 04:02 PM |
Mullet |
You can try these folks
Toolkraft Parts
P.O. Box 80777
Springfield, MA 01138-0777
Tel: 413-737-7331
Sales@Toolkraft.com
The Mullet
Dave |
Member Since
12/27/2008
Total Contributions
3 Posts
|
| Post Reply | Watch this Topic |
Parts |
02/24/2009 04:03 PM |
Mullet |
Try these folks
Toolkraft Parts
P.O. Box 80777
Springfield, MA 01138-0777
Tel: 413-737-7331
Sales@Toolkraft.com
The Mullet
Dave |
Member Since
12/27/2008
Total Contributions
3 Posts
|
| Post Reply | Watch this Topic |
triger switch for a Power Kraft radial arm saw |
09/06/2009 08:28 AM |
bgideon |
I need the trigger switch for my power kraft radial arm saw model 2610c |
Member Since
09/05/2009
Total Contributions
1 Posts
|
| Post Reply | Watch this Topic |
powr kraft TPC-2610C trigger switch |
11/19/2009 03:40 PM |
Jawdoc |
I have the Powr Kraft Radial Arm model TPC-2610C. The saw has worked perfectly for over 35 years under moderate use until today. It did not shut off until I unplugged it. Took the switch out and tried to disassemble it but the spring retainer broke and it can't be reassembled. Does anyone have a trigger switch for this model or a source? |
Member Since
11/19/2009
Total Contributions
1 Posts
|
| Post Reply | Watch this Topic |
 |
| | |
Moderated by Handyman 
