The exploded parts view of your model definitely shows 2-screws at the lower edge of the access panel (they're pan head, 8-18b x 0.31 part # 131168200 BTW).
Maybe they're just under a lip of the panel? I don't have access to an actual photo of the panel from your dryer to see how it was formed.
** would they actually be under the dryer on the bottom **
No. They should be accessible from the front without needing to raise the dryer.
** is this one of those that you use a screw driver to pop out the top of the kickplate and then lift up to remove? **
I think you're describing a procedure for a Whirlpool built model, yours is made by Frigidaire. The parts list for your model shows screws.
JMO
Dan O.
www.Appliance411.com/parts/?ref411=Kenmore+Dryer
The Appliance Information Site
=D~~~~~~ |
Member Since
11/12/2002
Total Contributions
3848 Posts
|
Moderated by DanO 
