My old driver seems to have sprung a leak each time I fill it with water. If I replace it, would it be difficult to install? I do see what looks like a hot and cold water valves...is there anything else I should look for? Thanks

If you're replacing an existing clothes washer, it is not usually too difficult (once you've gotten the replacement in place and removed the original). The installation instructions that come with the new machine should cover everything that is necessary including removal of any shipping braces from the unit but you can read an article about it at the following link:

Installing a Washing Machine

Dan O.
www.Appliance411.com
The Appliance Information Site

=Ð~~~~~~

[This message has been edited by DanO (edited December 01, 2002).]