Home > MyProjects > Step By Step > Bathroom > Bathroom Toilet Paper Cabinet

Bathroom Toilet Paper Cabinet

By: krieck
Filed Under: Bathroom as Step By Step
Last Modified: 10/09/2006 10:28 AM
Print VersionBookmarkEmail this page to a friend.
Report project?
Cabinet installed
[+] enlarge image

Cabinet installed

Looks great and really adds utility


Our master bathroom always seemed to be short of toilet paper. This cabinet purchased online from www.HoleInTheWallProducts.com solved our problem.
Trace the template that came with the cabinet
[+] enlarge image

Trace the template that came with the cabinet

Locate a place for the cabinet


After locating the studs in the wall and establishing where I wanted the cabinet to be, I traced the template that came with the cabinet in preparation for cutting the hole.
Watch your fingers
[+] enlarge image

Watch your fingers

Cutting the hole


Using a straight edge and utility knife I cut my hole following the outline I traced from the template. I used a utility knife but a drywall saw would work fine too.
Storing the cut-out
[+] enlarge image

Storing the cut-out

This is a good Idea


Following a suggestion from the web site, I stored the cut-out piece in the wall just in case I wanted to take the cabinet with me if I moved. I would then have a piece of drywall pre-cut to fit the opening for a drywall repair.
The tape is covered by the cabinet
[+] enlarge image

The tape is covered by the cabinet

Identifying the cut-out


I simply attached some fishing line to the patch piece and taped it to the wall with masking tape and labeled it. This is not necessary, just something I thought was a good idea down the road
A perfect fit
[+] enlarge image

A perfect fit

Installing the cabinet


The cabinet, called a Paper Pantry, has a cleat on the bottom that will engage the bottom edge of the drywall when installed and lowered into place.
Just slide into position
[+] enlarge image

Just slide into position

Install the bracket


The bracket that comes with the Paper Pantry simply slides up though a slot in the top of the cabinet and is fastened with two screws.
Just a couple of screws does it
[+] enlarge image

Just a couple of screws does it

Tighten the screws


When the two screws are tightened, the bracket securely clamps the cabinet to the wall.
Cut aroung the old one
[+] enlarge image

Cut aroung the old one

Removing the old dispenser


This was a simple drywall repair. Just cut the old one out. There is usually something behind it.
Some glue and a couple of screws
[+] enlarge image

Some glue and a couple of screws

Install a patch


There was a stud behind the old dispenser so I cut a patch to fit, put a little construction adhesive around the edges and screwed it to the stud.

A good patch


A tip from an old drywall guy I knew has allways worked well for me. On small openings, rather than going around it with tape, I use a piece of kraft paper, a paper grocery bag works well. Cut to fit about an inch over sized all around. Mud the wall for the paper to stick and then finish as you would a normal tape joint.
Three in and one out
[+] enlarge image

Three in and one out

This works great


This has worked out great. It keeps the paper close by, clean and out of sight.
The final shot
[+] enlarge image

The final shot

A beautiful addition


My wife liked it so much, I put one in every bathroom in our house. Four to be exact. They're great!

Discussion

Post Reply
Title/Content Author

thanks

01/21/2007 07:50 PM kathywhite

I have been looking for this kind of information for a while...thanks a lot.....can you please post some website that might help me more in deisgn and ideas... thanks in advance

Member Since
01/21/2007

Total Contributions
5

Post Reply
  Post Reply





 

About | FAQ | Contact | Sitemap | Privacy Policy | Terms of Use | Help
© BobVila.com 2008