I began by digging the footers 1' deep all the way around. I saved money by calling a local concrete company that delivered my concrete before they headed off to another job. Lots of companies will charge you a small load fee. However, if you're flexi
Thin plywood sheets were screwed to the joists to create plain solid surface Thin plywood sheets (3/16") were screwed up to the joists to create plain solid surface and the chalk line was snapped through the light fixture parallel to the long wall.
Created using broken concrete, block and concrete mixes. Fake tree's were textured using SBC Texture Rollers at www.BetterPaths.com Created in two days using home made light weight vertical cement mixes and hand carved and textured using SBC DIY Tex
Project is still underway...we are going to finish hanging doors today and start painting as well. I would estimate the time of completion around July 1. Our stock the bar party should be around the 4th...Woohoo!
Hand cut veneer all hardware self made (except knife hinges)
European Walnut and steamed Swiss pear
240 hours work, I made this under the gentle guiding hands of Hans Koot, the design was inspired by a Japanese teapot spout (the angled walnut end
