The Best Floor Sander for Beginning DIYers

Unless you plan to sand many floors in your lifetime, your best choice of floor sander is the random orbital sander from one maker in particular.

By Joe Provey | Updated Feb 28, 2020 12:56 PM

We may earn revenue from the products available on this page and participate in affiliate programs.

DIY Floor Sander

Random orbital floor sander with rectangular base. Photo: JProvey

Unless you plan to sand many floors in your lifetime, the best choice for do-it-yourself floor refinishing is the random orbital sander. Sure, it may take longer to remove old finishes than it would with a drum sander, but you don’t need a lot of experience to operate a random orbital sander and most importantly, it’s less likely to permanently damage your floor by causing grooves or valleys that are impossible to fix.

I have found that Clarke-American random orbital sanders on are the easiest to use of the models available for rental at most home centers. (View example of a Clarke orbital floor sander on Amazon. Pricey, no? This is why most folks rent.)

In my opinion, the U-Sand—another model commonly found on offer for rent—is far more difficult to control, and because its sanding surface is relatively compact, it can take longer to do the job. Making matters worse, four-disk units like the U-Sand offer little or no padding under the disks, so the abrasive does not lie flush to the floor, further reducing the available sanding area while slowing down the process even more.

Random Orbital Floor Sander Pads

Pads attach to the sander base. Photo: JProvey

Just because you’ve rented a random orbital machine doesn’t mean there’s no need to be careful. Be sure the sander is running at full speed when you lower it to the floor. It is also important not to move the sander too quickly across the boards. Above all, remember to never turn the machine off while it is resting on the floor. For any of these different mistakes, the consequence is the same: circular scratches on the floor surface. They may not be very noticeable as you’re sanding, but they’ll definitely show up when you apply the finish.