We own a stilt house on the florida west coast. There is a ground level, a first floor, and second floor. Both the 1st and 2nd floors have bathroo...
COMMUNITY FORUM: PLUMBING
Hi, I recently purchased a Fleck 7000 controller/valve water softener but I noticed I am not able to select the "metered delay-variable brining"...
One of the 2 showers of my house makes loud noises which increase or decrease with the amount of water let through. I was told that the reason is ...
Hi, The faucet in the tub is in good shape, no leaks etc. But when you turn the shower on very little hot water comes through the shower head, i...
I've just installed a bathroom sink, and noticed a small leak coming from joint between the rubber gasket and the metal washer. The seal between th...
Any suggestions for a sink faucet for a remodeled kitchen in the price range of $150-200. Delta and Moen are the 2 brands I hear most. Thanks.
I have a question....if I have a toilet that has been running 24/7 for a month is it possible that I could have ran out 74,000 gallons of water? I...
After trying to locate a drip and tearing out 3 areas of wall, I finally discovered the source was a small nail hole in some PVC piping. Is ther...
My pump is going on even when no one is running water. I went around the entire house and can't find any leaks. I checked outside faucets and they...
When I flush my toilet, a howling sounds occurs and it takes a long time for it to refill, which it does quite loudly. I have run the sink faucet t...
We are having a problem. We have hard water and we get a build up of rust. To fix the problem when the build up is getting bad I take of the wate...
We have very low water pressure. We can't water, do a load of wash, take a shower, use the sink or flush a toilet when we are using any other wate...
Have a crack in the shower pan. Wife wants to remove entire stall and install a whirpool bath and shower. My question is. The shower currently drai...
I have a fiberglass shower that sinks about 1/2" when you stand in it. It was hitting a support under it and pushing the drain up and causing a lea...
I was trying to remove a moen cartride with the cartridge remover and I think I only removed the core (the inner metal piece). Based on the new re...
I'm not sure, but I think that we may have a 3/4 pump at our cottage. Could it have to do with our pressure tank? Also, should we have two pipes ru...
I'm hoping someone can help me with a problem I've been having. In March, I purchased an older home (built in the 40's). As a condition of purchas...