I am just about to begin installing a backup sump pump to my existing sump pump. How hard is the installation? I need to know the difficulty leve...
COMMUNITY FORUM: PLUMBING
Our kitchen faucet normally has excellent water pressure. However, of late, it has dwindled to 50% of normal pressure. If our water has been off fo...
We have moved into an old 1945 home. Our main water room is on a septic tank, which we just had cleaned. Our problem is our toilet does not flush. ...
I'd like to install a toilet in my basement. There is a drain that could be used for one but it is located under the stairs and therefore has no a...
I live in a condo that is three stories high. Wooden structure. The complex was built 3 years ago. The piping in these units is "cpvc". This noise ...
We live in a 50+ year old home. The cast iron waste pipe is rusted through (a slight hole) leading to the septic tank. I've put a temporary patch...
I pulled out the knob for the shower to turn on and the water still came out of the faucet, I pushed in the knob and the water is still coming out ...
Not being too much of a handy man, I find myself in a precarious position. I am trying to replace the cartridge in the shower's mixing valve (whate...
My home is approximately a year old. The sump pump that was installed in the house used to run ok (a little noisy), but now it runs continuously. ...
I am doing renovations to my basement that includes relocating my laundryThe new location is not practical to reach either of the two waste stacks....
I recently had asbestos insulation removed from the steam pipes that run from my boiler to the radiators in my house. Now I'm wondering what kind ...
I have a Kohler undermount bowl and a granite top that I need to assemble. The instructions for the top specify a Kohler bowl which I have. The top...
Does anyone have any experience with thermal expansion tanks? My water pressure increases noticeably after the hot water has been running. I don'...
I am having problems with my hot water that just don't make sense to me. I have a hot water tank (gas) that is plenty big enough for my house and ...
How tough a job is this? The existing sink is wall-hung with two metal legs at the front corners, bendy tubing leading to the faucets (I'm replaci...
I'm currently having problems with what I assume is the hot water cylinder, 6 months ago we used to get a full bath of hot water, this has diminish...