I AM PLANNING ON BUILDING A GAZEBO IN THE SPRING. I HAVE SEARCHED FOR INFORMATION ON HOW TO WIRE A GAZEBO ON THE NET, WITH NO LUCK. I WOULD LIKE TO...
COMMUNITY FORUM: ELECTRICAL & LIGHTING
This is a Model 790 46803 992 which was made by WCI in 2000 whoever that is. I think I need to replace the ERC or EOC from researching the other m...
Hi,I live in TX and this summer we had to refill the condenser unit with the refigerant twice. We found out there are 3 holes in the evaporator coi...
I have a light fixture in my kitchen with 3 bulbs that stopped working. I bought a multimeter and checked power to all three sockets and get 118v ...
Hi, I'm new member of this forum. I'm a electrical contractor in Australia. For more information visit here :- http://www.amjelectrical.com.au/...
I have a Kenmore dryer (110.66814694) that shuts off part way through a drying cycle and it appears that it is from overheating. When it shuts of...
How does one know which smoke detector needs a new battery? In our home, the beeping of a dead battery seems to be coming from multiple units. We...
Hello, I just bought a central vacuum. I need to put a 15A breaker. The unit works on 220/240v. The plug that I have is nema 6-15r. My load c...
Can anyone tell me what type of surge protector is recommended for behind a refrigerator? Is there a type that's an actual outlet that can take the...
I want to wire my floor lamp so that I can plug it into wall and turn it on by wall switch. The plug is ready. When I opened the lamp and removed...
I just bought some new light fixtures to install in my 1984-built home. They are labeled: "90 degree C supply conductor minimum. Most houses built ...
How can I wire exterior soffit lights to be controlled normally by a photocell, but if needed still be turned on or off with a switch. Ive seen it...
We purchased a home about a year ago that had three hard-wired smoke detectors installed. All of them were BRK Electronics Model 2002RAC. All h...
I AM PUTTING A NEW WIRE IN A LAMP FOR A FRIEND. THE PACKAGE THAT THE WIRE CAME IN , SAID TO CONNECT THE RIBBED WIRE TO THE SILVER SCREW AND THE OTH...
does anyone know where to purchase a replacement to the defond switch cym 1213 used on a toro blower
I bought an air conditioner that is to fit in a window that slides vertically but my windwow slides horizontally. How do I install it?
good airflow, changed tstat, heat selection makes no difference in heat, cycles between 250 and 120 inside dryer. any suggestions
I have a Kenmore Elite HE3 Dryer Model# 110 82826101. It turns off periodically showing the error code E1. I read earlier posts that it's the Therm...