I cannot get 2 of the 4 wires to go into the hole. they just keep crimping and bending and I tried a paper clip but nothing will work to get the in...
COMMUNITY FORUM: ELECTRICAL & LIGHTING
Detector in hallway woke me at 4AM blaring like there was smoke somewhere but there wasn't. It quit after a little bit but then started again this...
Hello Bob, I recently had a baseboard heater put in by a handyman. I notice about 1/4 of the heater is attached to pressboard wall covering and t...
We have recently purchased a home built in 1896 in Concord, NH and would like to maintain the homes architectural and historical integrity, but hav...
I have a General Electric side-by-side TFX24R refrigerator (1991 installation) with an icemaker that has developed a leak on the dispenser in the d...
Hi! I have GE XL44 (model#JGBP34GEP) and was working fine but on one fine day I decided to experiment with StoP TIME AND COOK TIME and all of a ...
I have a switch on my wall in my master bedroom that that controls an outlet on a wall. I would like to install an over head light on my ceiling....
What does it mean when you turn of a light switch but the light does not go off, when you the switch off one light gets brighter the other one goes...
HOW DOES IT COME OUT? I HAVE 3 SCREWS REMOVED BUT CANNOT TELL IT THE BOTTOM ONE LEFT IS A SCREW OR A CLIP, IT A SCREW HOW DO I GET TO IT.
I have a GE side-by-side of indeterminate age. Frost-free. I noticed a faint smell like electrical burning on Saturday, on Sunday noon I put some t...
Hi, We are finishing a basement and have all the outlets roughed, and some of the ceiling lights as well. One one side we have 8 outlets, n...
Hello: I purchased an orange Bob Vila Battery Back up from HSN a few years ago. (to jump start car, run computer etc during power outage.) This ...
I am trying to replace my exhaust fan in my bathroom and when I disconnected the wires from the old fan my bathroom ceiling light lost power. They ...
I have a 2002 Kenmore microwave, Model #363.62702200 that just stopped working today. Last night it worked fine. Today cold food. The unit is a ...
I'm working on a house built in the 1980's. There is one gfci in a metal outlet box that extends directly from the breaker box via metal conduit (a...