... Wiring a NEMA 6-50R for an Eastwood 200amp ac/dc welder which has a NEMA 6-50P plug, which Operates on either 110vAC, 15-amp circuit or 220vA...
COMMUNITY FORUM: ELECTRICAL & LIGHTING
How can I wire a three way switch circuit for a 240 volt, 30 amp, single phase, 5hp air compressor
OK, I've asked a couple of electricians this question with very hazy answers. I think I understand the purpose of a 20 AMP circuit (like going to a...
We purchased a home about a year ago that had three hard-wired smoke detectors installed. All of them were BRK Electronics Model 2002RAC. All h...
Hi, Please forgive my ignorance. I need to install four 110v outlets in my back yard for an above ground pool (2 for pool, 2 for convenience). M...
Changing a light fixture to a ceiling fan. I have 3 switches in the room. 2 controlled the light before and 1 was dead (1 3-way switch on one wall,...
I had to replace my kitchen light. It was simple, connect the ground wire with the ground wire on the fixture and cap off. Connect the white wire...
Our 2 floor house has 7 smoke alarms originally installed 15 years ago. We keep the batteries updated at the Daylight time changes, even though we...
We have all Mobile phones original , unlocked and can be use in any country . All brand new with the complete accessories in original factory seal...
I have a 10 year old fan in the bedroom that I put a universal fan remote kit in about 6 years ago. It has always worked fine until recently. All...
Just moved in my new home. Having problems already. The washer circuit breaker has already gone off. Since move-in, the dryer has never dried items...
I am attempting to install a Genie 500 garage door opener. The home is -3 years old and door is 7' high 2 car. Wiring was pre installed. Problem is...
I bought this used this week. Model#GS22Y8DV serial#12455906MF. The freezer doesn't freeze but it has frost in the inside back of freezer and coil...
I currently have a drop in range, but have my eye on a new free standing. Will there be massive reconstructive surgery to make this happen, or is i...