I have a seven-year-old, two story colonial that I would like to add a front roofed entryway portico to. I cannot find any information anywhere on ...
COMMUNITY FORUM: HOME DESIGN
Hi, I was wondering how difficult it would be to remove the roof on the back part of my house and add a flat deck up there. I have a picture of wh...
I am wainscoting a bathroom and will butt up against bullnose tile. Is there anything special I need to do, sucha s run verticle molding, to visua...
What is the percentage change in price when comparing stick, panel and poured concrete (with no insulation) type homes with size and finish being t...
I want to build a shed that is 6' x 14' and 2 sides will be attached to the house. One 6' side and one 14' side will be the sides that are attached...
I have discovered that the wallpaper in my new home was pasted directly to the drywall. I had determined that I would paint over it in a room wher...
I want to add a greenhouse in my yard in Mass to enclose a pool but was curious if I created a base out of 6x6's laying them flat at ground level a...
I bought a house and took out the carpet that has been there since it was built. 1950's, and apparently they glued the indoor/outdoor carpet direct...
Any ideas or suggestions on how to redo an old formica table top? Table legs are painted white.
Any ideas/suggestions on how to redo or replace an old formica table top?
I don't have a clue other than I envision a 6 to 8 foot bench made from 2x4's somehow. Supported on each in the middle by 1 4x4 inch post.Does anyo...
We are looking to add a 4 season sunroom with a vaulted ceiling to the back of my 20 year old split level. I am going to tear out the 16 x 16 groun...
we just bought a house built in 1968, and there are 5 branches of aluminum wiring. they have pigtails and antioxidant grease at the moment. our ins...
I am a new home owner. I have a 3 car detached garage and a 2 car attached garage. I want to make the attached garage into living space. Current...
We just purchased a 100+ year old house. We started to take down one of the walls and found that it is a bearing wall. How do we go about complet...