Am looking for styrofoam ceiling beams. Where may I purchase them ? Thank you, Glenda Stewart Burianek, email@example.com
COMMUNITY FORUM: HOME DESIGN
I want to put burlap on the insets of my kitchen cabinets....put small trim around edge to cover edge of burlap...stencil a design on the burlap......
I will be having a contractor lay a new maple hardwood floor in a condominium I am purchasing.I have heard from a few sources (including he contrac...
We have a sisal (or some kind of natural grass type fiber) area rug with no backing, and it seems as if a significant amount of very fine dirt accu...
I have a seven-year-old, two story colonial that I would like to add a front roofed entryway portico to. I cannot find any information anywhere on ...
Hi, I was wondering how difficult it would be to remove the roof on the back part of my house and add a flat deck up there. I have a picture of wh...
I am wainscoting a bathroom and will butt up against bullnose tile. Is there anything special I need to do, sucha s run verticle molding, to visua...
What is the percentage change in price when comparing stick, panel and poured concrete (with no insulation) type homes with size and finish being t...
I want to build a shed that is 6' x 14' and 2 sides will be attached to the house. One 6' side and one 14' side will be the sides that are attached...
I have discovered that the wallpaper in my new home was pasted directly to the drywall. I had determined that I would paint over it in a room wher...
I want to add a greenhouse in my yard in Mass to enclose a pool but was curious if I created a base out of 6x6's laying them flat at ground level a...
I bought a house and took out the carpet that has been there since it was built. 1950's, and apparently they glued the indoor/outdoor carpet direct...
Any ideas or suggestions on how to redo an old formica table top? Table legs are painted white.
Any ideas/suggestions on how to redo or replace an old formica table top?
I don't have a clue other than I envision a 6 to 8 foot bench made from 2x4's somehow. Supported on each in the middle by 1 4x4 inch post.Does anyo...