Furnace fuel pump "whines"
Our oil-fired furnace (Thermo Pride)used to be fed from an underground tank and was set-up for a two-line system. Due to some construction, that tank was no long...
Our oil-fired furnace (Thermo Pride)used to be fed from an underground tank and was set-up for a two-line system. Due to some construction, that tank was no long...
0
answersI am installing baseboard heat in my basement the tubings runs high and then drops to the baseboard,then goes back up. Do I need to put one air vent for the whol...
1
answersWhile getting an estimate for a new furnace the salesman rec a Second Wind Air Purifier which has a germicidal lamp and an ozone generator to remove smells in the...
0
answersI used to have a didgital thermostat that would record the time a furnace ran over 24 hours, one week, one month and one year. My new house doesnt have one like t...
0
answersFirst does anyone know if hot water cast iron radiant baseboard can be used in conjunction with standard finned baseboard ? Either in the same run, or on a separa...
0
answersI'm considering installing a 2.5 ton a/c system as part of a renovation of a 1920 bungalow style house. Aside from the final charging of the system and the elect...
1
answersi'm thinking about getting a high efficiency furnace instead of replacing my gas furnace, but i'm not completely familiar with the direct wall venting requirement...
0
answersI have a fully working chimney which was thoroughly inspected and cleaned before I had a gas log system installed. The vent remains open slightly all the time. Af...
1
answersI'm purchasing a new house and have the option of having a Honeywell air cleaner cartridge installed on both of my Trane air handlers. Installation cost is $450/...
1
answersI have a new zone for forced hot water heat in the basement. How do I figure how man pieces of baseboard do I need. The room is 29X19' 551 sq ft. Can someone ...
0
answersHi,My heating system is floor radiant heating with 6 zones. 5 themostat are honeywell and 1 is white rogers brand. All are simple 2 wire / mercury type with an...
0
answersI am finishing off my basement and have it 75% framed. How do i know how many heat registers/cold air returns i will need for the space (approx 1000 sq ft)Is the...
0
answersI have a coal furnace. When the power goes out the pump stops circulating the water in the pipes and the pressure causes the water to escape through the relief va...
0
answersHi, my old thermostat is mercury type is it worthwhile to replace it with a non-programable digital type of thermostat?If yes, please advice brand and model.Thanks
1
answersI am having problems with my lennox G16R furnace. It worked great last winter and this year it comes on sometimes but if the furnace has been running off and on ...
0
answersI've got a Majestic vented gas fireplace that has suddenly started shutting itself off after about an hour of use. The pilot goes out but it re-lights without a ...
0
answersHi I have the following installation of my 12 year old radiant heating with gas furnance system. 4000 sf area.The problem i am having is zone 4, zone5 and zone6...
0
answersI have a slab home with oil heating and my living/kitchen area gets really cold and I believe I'm burning more oil than necessary. There is a big difference in te...
1
answersIs there a recommended cycle time for oil burners? How often should it turn on/off? What is considered excessive?Thanks
0
answersI grew up with central heating, and my parents always turned the heat down while we slept (to 68 F, I think) then back up when we got up in the morning. I have b...
4
answers