I have a old single-story home that has exposed floor joists on the first floor. Because of this architectural feature my attic has a flat floor o...
COMMUNITY FORUM: HVAC
When my oil fired boiler heats up, i'm getting loud banging from all my radiators. The boiler was cleaned and checked at the end of the summer. O...
Good Day:I plan on converting mt attic into useable space, actually I have done on the floor, wall, part of teh electrical, heating, etc..now I am ...
How do you remove electrict radiant heat in the ceiling?? My understanding is that it is under the popcorn stuff.
Could someone give me a rough estimate on how much it would cost to replace my old oil furnace with a new one? My house is 1800sf and has forced h...
The 1922 colonial I recently moved into has R-19 FG batts between the basement ceiling joists. I have a hot water heating system (gas fired boiler...
What thermostat model and brand should I install in a Reem heat pum Unit with a 2 stage?
Hello,My current thermostat is in a south facing room, which is warmer than the rest of the house (north side). Is there such as thing as a remote...
A contractor recommended that I replace my ac coil as I am having a new furnace installed. Is this necessary? I am undecided about replacing the c...
I am considering the purchase of Rheem Classic 90 Plus, A Rheem 80%, or a Goodman 92% GMPN60-3 gas furnace.Any recommendions on which one to go wit...
Hi All.I'm looking at getting a 90%+ Trane gas furnace to replace a 30 plus year old American Standard unit. The old furnance is 55% AFUE, and is ...
Hi, I'm in the process of remodeling my basement and as such have completely redone the ducting of my forced hot air furnace in the bottom floor. I...
I currently have steam heating with cast iron radiators. Can this system be converted to radiant floor heating in specific rooms?
I am preparing to finish my basement. It currently has a foil faced fiberglass insulation riveted to the concrete perimeter walls. My question is ...
My husband and I are building a 1 1/2 story home and we are interested in installing a whole house fan. Our questions are ... Will these fans work ...
I recently moved into a 1922 2-1/2 story colonial in Baltimore, MD (hot, humid summers and fairly cold winters). The previous owner did a poor job ...
My dryer vent (standard 4" round metal pipe) goes through my basement box sil. When they put it in, they drilled about a 5" hole, and now there is...
I'm installing an exhaust fan in a bathroom. The ducting (rigid) will be run in the attic and will terminate at a wall vent on an exterior wall. ...
Why hasn't any one come up with a thermostat that opens and closes air registers based on the temperature in the room where that air register resid...