Retrofit fins for baseboard heater pipes?
I'm looking for a fin supplier for retrofiting fins to lengths of installed naked base board heater pipes rather than replacing the bare pipes wit...
COMMUNITY FORUM: HVAC
3 months by BV000532
1
answers669
Views
Vent free Gas fireplace pilot light wont stay lit
I purchased a vent free gas fireplace this past spring when they were one sale at a local store and it seemed to work fine with the little testing ...
3 months by BV000193
3
answers1346
Views
Central ac in old home
I have no duct work and no crawl space in an old house. Are their ac systems for older homes with this condition. I can install probably all of it ...
3 months by BV000193
5
answers193
Views
Advantages/Disadvantages of Indirect Hot Water Heating
I am remodeling a house that currently uses a hot water boiler heating system to also heat a hotwater tank for general use. In winter, this seems v...
3 months by BV000406
4
answers977
Views
Dusty House after renovation......
I have a house that was built somewhere in the 60's. I purchased the house (cape cod, unfinished attic and basement) last year after it was abando...
3 months by Gerald M. Copeland
1
answers262
Views
heat loss through knotty pine vaulted ceiling
This is a challenge. Last year we moved into a house with a living room with a 45 degree vaulted ceiling that opens up to the upstairs landing whe...
3 months by BV000348
1
answers756
Views
King Circulator Wood Stove Info
I've spent some time on this site and all over the web looking for some information on the King Circulator Wood Stove model 8802-B by Martin Indust...
4 months by BV000342
3
answers1233
Views
Replace a wick on a dyna glo RMC-55-R7 kerosene heater
I recently baught a dyna glo RMC-55-R7 on ebay. However it didn't have a wick. I know where I can buy a wick, BUt I don't have a owners manual. How...
4 months by BV000340
12
answers3167
Views
arcoaire furnace
Thanks for the reply about bypassing the safety controls on my furnace. Now I understand how you operate. I was checking the validity of the advi...
4 months by BV000338
8
answers717
Views
Air Handler in the garage insulated
My Air Handler is in a closet (closed no vents) in the garage. It was sweating a lot so my husband used insulation and wrapped it around the exter...
4 months by BV000336
0
answers185
Views
parts for stone silent glow kerosene tub heater
I have a tube heater that we use in the garage. We bought it from an auction and used it for years. Now it won't run right. Does anyone know where...
4 months by BV000324
1
answers871
Views
Porch Enclosure
I have a front entry which is enclosed on three sides. It is about 18-20' tall, reaching up to the 2nd floor of the house and measures ~10' x 10'....
4 months by BV000305
0
answers162
Views
Re: Central Electric Furnace
how do i wire a replacement blower motor on a eb17b central electric furnace
0
answers376
Views
furnace blower won't always shut off, heating mode only
Hi! I recently bought a house with a Dettson oil-fired forced air furnace, with a Heil heat pump. Both were installed in 1989, according to the re...
3
answers2071
Views
Geo thermal heat pumps
Are there any positives or negatives anyone would like to share. I am looking to install this system in my new home.
4 months by BV000217
0
answers171
Views
Forced air gas furnace
Mr Vila, My furnace never reaches desired temp (69)..I hear the burner light..a couple of seconds later the blower kicks on and just keeps running...
1
answers260
Views
Cold Air Return Noise
Our new Carrier two speed furnance, for this new ranch home, is located in the basement, under the hallway near the three bed rooms as per the arch...
4 months by BV000202
3
answers900
Views
lennox g16 ignition module replacement question/problem
hi all, i just replaced my robertshaw 735L with the honeywell 53L90 ignition control. i've connected all the wires based on their instructions but...
4 months by BV000201
2
answers617
Views
Intertherm baseboard heater parts
hi. I have an old intertherm 'softheat' baseboard heater (model EBH 1500, 240V), and the limit switch inside has broken. I know that Cadet bough...
10
answers1957
Views
Gravity furnace pilot breather tube
I have an old coal gravity furnace that's been converted to natural gas. I'm having trouble with the pilot kinda. The pilot works and stays lit. Th...
4 months by 2cheap2callaPro
0
answers291
Views
