I remove a bearing wall that held up beams, what is the best was to shore up these beams, without rebuilding a bearing wall again, so they will hold.
COMMUNITY FORUM: MISCELLANEOUS
We replaced a sink and cabinet that was made in the 50's. Both aluminum strip moldings were ruined and I would like to know if these aluminum strip...
Can you suggest a way to remove both silicone and latex caulking from a fiberglass tub enclosure?Thanks, Joe
i would like to have a website to go to order a rooling library ladder like you see in large libraries. also would like plans so that it can be ins...
I am building a room using part of my garage. I need advice on what would be the best way to build a floor on the garage cement floor. I would lik...
Greetings,I'm looking to get a list panelized distributors for the Colorado area, in particular, Park County.Thanks in advance.
Hi, does anyone have any experience having a wired home security system installed in an older home? To put in a wired system in an old home with m...
I have been looking for a peephole with a cover or little door. I can not find one anywhere--I have searched all the hardware stores in San Antoni...
What company do I contact for info on the log "elevator" that was installed to carry firewood from the basement to the first floor of Bob's own hom...
I'm having a home built in another state and frequent visits by me [a novice] to watch the progress of contruction will not be possible. The builde...
I am making some table top fountains out of pieces of granite countertops. What type of drill bit would work best? [This message has been edited by...
My house has a brick facade over a wood frame, and the mortar is starting to show a lot of wear on the facade. I have read a lot about tuck pointi...
I have a desk drawer that will open by itself. It will stay closed when I close itfor a while, then if I bump the desk (whichI do often while I'm ...
I have an 1925 house in Fort Myers Florida. Water undermined the foundation of the front porch. Over the course of years goine by, one side of the ...
Before I can replace my worn-out furnace, the building inspector says that my chimney has to be ceramic lined. I know its lined with something but...
We are redoing a add on addition that was built using concrete block. We have tore everything out and need to hang drywall but we are unsure of wha...
We are in a newly built house and there is water in the second story bedroom closet. Also, we have just had our first heavy rainfall for the season...
Are deck blocks strong enough for the posts to be set in? The piers are 8' apart. I am using all cedar posts with treated lumber for the floor jois...
Does anybody know what the company was that made the camra's viewable over the web on a recent show? I think they were advertised as being useful ...