Does anyone know what make/model this faucet is???
Get Help from Bob Vila
- Give-Aways & Offers
- Monthly Must Do's
- DIY Project Ideas
- Step-by-Step Guides
- Inspirational Photo Galleries
I have a kitchen faucet that I am unable to determine the brand. It is dripping - would like to get kit to repair. I am unable to download phot...
What tool works best on the GE BREAKER BOX Panel Ground Terminals?
Our dishwasher wasn't running , hadn't used it for a couple of days when all of a sudden it started up and hot water came all over the floor.I shut...
Next door neighbors to my investment foreclosure property saying that I will have to take out old septic tank and place new one on the other side o...
The toilet will not flush completely and the toilet will not fill back up completely. I lifted the back of the toilet tank up and the flushing mech...
Does anyone know where I can get a vacuum breaker replacement kit for a prochannel sillcock? I have gone to a few stores and none of them fit.
I purchased a home recently, and the jets in the master bath tub were rust-stained (the house was built in 2002). In the process of removing them ...
I have discovered a nail which I am at a loss to name or work out what it's purpose may be! It is 1" in length, has a point like two arrowheads at ...
The Paint Piranha is a device that cleans paint brushes and roller covers. This device has been featured in This Old House magazine. There are 3 st...
I have a SW model# GCX-105N that needs the heat exchanger replaced and don't know where to find one
I purchased a used 10 inch sears RAS Model 113.196321 and found a bad bevel gear, part number 818164, but it is no longer available. I am looking ...
My kitchen faucet is broken and I can't identify it. The hose guide in the end of the spout is broken and the sprayer doesn't fit correctly and no...
We are in need of 1 to 2 boxes of dal tile spicy gumbo 12x12 tile, any suggestions?
I am retired and on a fixed low income. My house walls are very cold for the ones that are between the outside outdoors and the inside of the house...
Hi, My basement ceiling had water, gas, and cable lines below the joists so I recently strapped with 2X4's perpendicular to the joists at 24"oc...
I just acquired an old Dunlap Lathe Model # 534.0601 that was apparantly made by the Atlas Press Company and sold by Sears Roebuck sometime between...