Does anyone know where I can purchase replacement belts for a Powr-Kraft table saw (circa 1968) Model 2746 / Series 76X. The belt model number is ...
COMMUNITY FORUM: PARTS & SUPPLIES
I have inheritted a 9" radial arm saw from dear old dad who purchased new in the late '60's, the model # is 113.29350. My problem is with the motor...
I've just received a stove and I need to find some information about it and also find some parts for it?
Does anyone know where I can find one? I need one that is at least 60" high and 48" in length. Thanks!
Does anyone know where I can get parts of an Ironbridge at Coalbrookdale 1980 CBD woodburning stove. I am looking for the feet(or maybe they are ca...
Hi, One of the "disappearing springs" on my attic ladder snapped and I've been having a tough time locating a replacement. The ladder is at leas...
In prepping previously painted drywall for paint, I repair nail holes with lightweight spackle, sand that with a sanding block and then apply an ac...
Does anyone know where we can purchase a clock motor for a Seth Thomas clock model E720-001. Motor is NW M5A-115-60cy
New dad (recently widowed) looking for instruction manual for Kenmore Model # 1249180 Much obliged......................321dad
Can anyone recommend a sealant or caulk that I could use to plug some screw/bolt holes in a new metal storage shed that was shoddily installed? I'...
I'm looking to replace a built in hideaway ironing center (ironing board that mounts on the wall) with a rolltop cover instead of a hinged door. A...
My Ceiling fan has two chains, one for the fan blades and one for the lights however the chain for the lights is stuck. Is there any easy way to fi...
does anyone know where i could find schematics. my grandpa asked if i could find him some schematics for a craftsman Hydra LT 4000 Hydro Drive lawn...
i have to get 5 covers for my window wells. I have gone to ********** and ******* and they either have crappy plastic ones for 15 dollars or reall...
I want to chip seal my driveway but I can not figure out what kind of glop to get or where to get it. The nearest I've found is Henry 532 but it is...
Does anyone know where I can rent a shop vac with a hepa filter? There's a possibility that we've got lead paint, and we want to clean it up safel...
***** 42" Rotary Mower model number 917.253151 looking for three lawn mower blades part number (9484H), not available from the ***** parts store. I...
I have been told that there is a preassembled ceder shake shingle over black paper onto plywood product available. If you have a website or know o...
I am trying to find a Guard Assembly (Part No. 62279) for a Craftsman Bench Saw - 8" Tilting Arbor Model No. 113.242820 I have contacted the ret...
hi we're building a utility shed and have been looking around for shed doors (double doors, prehung, steel). unfortunately, we can't seem to fi...