I have a corrugated galvanized steel roof over my log home. I have problems with snow slumping off the deck roof onto the walk below. Does anyone...
COMMUNITY FORUM: ROOFING & SIDING
Is the starter course on architectural shingles the same as 3-tap shingles? I plan on applying daps of roof cement on every shingle for a sure hold.
Hi, The vinyl siding on my house is loose in many areas. It was purchased with a lifetime guarantee, but sadly the company went out of business. ...
I bought an early 1900s house. The garage has wood siding. I need to find other materials than wood boards to replace the failed, rotted, and warpe...
Hi, Just had home inspected and found that rafters and or plywood of roof sub-deck is sagging or delaminated??? Also it was either rafters or pl...
Hi I hope someone can help me? This is my situation, I was asked to build a two storey addition plus basement, the terms were i would build the...
I am in the process of putting a metal roof on my house. I am going over the existing roof by screwing furring strips every 18 inches on center, t...
Should there be a screen or some type of covering to stop critters from getting into the attic. We live in Texas and are noticing frogs and chamel...
Hello,I have a chimney that the cap rusted on and stained my shingles. I have ashpalt shingles, light gray, and the rust is noticable. I tried CLR ...
Getting ready to paint after fake brick tear off. We've removed the fake brick from the exterior of our 1920's house, and let is sit for a year. T...
My house is 100 years old, & had 4 layers of siding on it. I am peeling all the layers off (down to the sheathing/planks), & putting vinyl siding ...
I have a roll of White Rubber with a grey back that I want to put on my flat roof. Can I use contact cement to glue it to my roof? Do I h...
I have an open beam ceiling of 2x6 tongue-in-groove wood laid on an upper and lower beam. There is no insulation. I want to replace the pitch & g...
Do I have to prime before I paint asbestos siding? I have read 100's of articles and posts about the dangers of asbestos siding. They all discuss t...
I had my beat up tin roof replaced with shingles in an old victorian a year ago. I climbed up yesterday to fix a gutter and saw a 9x9 ft patch of r...
We had Sears vinyl siding installed last year and really love it. I had already purchased a Sunsetter Awning and want to install it. Any advice o...
I have a section of aluminum siding that is loose. Does anyone have any suggestions on how to resecure the area? It is at the base of the outside o...
I have several very low pitch out buildings the have rolled mineral surface roofing on them. Several different manufacturers (CertainTeed, IKO, US...
What is better for 30# tar paper requirement? 1 layer of 30# paper or 2 layers of 15# paper?