Should there be a screen or some type of covering to stop critters from getting into the attic. We live in Texas and are noticing frogs and chamel...
COMMUNITY FORUM: ROOFING & SIDING
Hello,I have a chimney that the cap rusted on and stained my shingles. I have ashpalt shingles, light gray, and the rust is noticable. I tried CLR ...
Getting ready to paint after fake brick tear off. We've removed the fake brick from the exterior of our 1920's house, and let is sit for a year. T...
My house is 100 years old, & had 4 layers of siding on it. I am peeling all the layers off (down to the sheathing/planks), & putting vinyl siding ...
I have a roll of White Rubber with a grey back that I want to put on my flat roof. Can I use contact cement to glue it to my roof? Do I h...
I have an open beam ceiling of 2x6 tongue-in-groove wood laid on an upper and lower beam. There is no insulation. I want to replace the pitch & g...
Do I have to prime before I paint asbestos siding? I have read 100's of articles and posts about the dangers of asbestos siding. They all discuss t...
I had my beat up tin roof replaced with shingles in an old victorian a year ago. I climbed up yesterday to fix a gutter and saw a 9x9 ft patch of r...
We had Sears vinyl siding installed last year and really love it. I had already purchased a Sunsetter Awning and want to install it. Any advice o...
I have a section of aluminum siding that is loose. Does anyone have any suggestions on how to resecure the area? It is at the base of the outside o...
I have several very low pitch out buildings the have rolled mineral surface roofing on them. Several different manufacturers (CertainTeed, IKO, US...
What is better for 30# tar paper requirement? 1 layer of 30# paper or 2 layers of 15# paper?
Any opinions on this job? What about the valley and how the line flips directions? http://www.photolava.com/code/1e54,1e55,1e56,1e57,1e58.ht...
I have the asbestos shingles. Several shingles are cracked or broken. Is there another material that I could fill them in & attempt to mold the s...
Hi I have a long sections of solarium extending through out the back side of my house.It is intergrated into the bedroom , bathroom and dining r...
Are there any concrete roofing tile (light weight shake style) manufacturers/installers anywhere in the northeast? I live on Cape Cod in Massachus...
We are considering a new metal roof over our present shingles. Have been told it is preferable to have standing seam on a residence as opposed to ...
I purchased an older home, 1920's style about 4 years ago, and apparently one of the valleys has been leaking into my attic for a bit unnoticed and...