I have a model number 137.248830 Craftsman 10" table saw and need a used or reconditioned motor, part number OQEF.
COMMUNITY FORUM: TOOLS & WORKSHOP
I have mixed the charger in with a box of other wall chargers. Does anyone know what input/output voltage and amperage is supposed to be for this ...
HELP!!!!!!!!!!great website - need help deseparately - i have a dining room table and two end tables and a cabinet - that are very old but very stu...
Hello guys. I'm a newcomer here and I have this terrible problem at my kitchen pipe. The pipe plug seems not to be working anymore now as I ...http...
The auger stopped turning. The shear pins are intact. The impeller turns fine. Any thoughts what it might be before I open the gear box?
My window and door frames are old and beat up. I don't want to paint them b/c I'd like the wood to show. What is the best technique for refinishing...
I have a 19?? Wayne Air Compressor Model 376V (AC4120). The unit stills runs but it is a little slow filling the tank up. I have researched Wayne ...
Attention all contractors, treasure hunters, and lovers of construction -- BOB NEEDS YOUR HELP! To re-install the original hinges removed from a...
The switch on my Craftsman Auto-Scroller Saw 315.17251 apparently died...it now runs as soon as it's plugged in, obviously unsafe. ***** says the ...
Hi folks Anybody know a source for a raising crank bar and handle with gear end for Shopmate 10" radial arm saw Great Britain or elsewhere warme...
I'm new around here, but I was hoping for some help on a moulding mess. We're doing 4.5" wide crown moulding in a 1920's Chicago apartment with pla...
Wife was kind enough to find a deal at a garage sale. Unfortunately no manual came with this bargin. Anyone have a manual they could e-mail. Thank...
I am building a closet in our office to make it a bedroom. The chimney runs through the room. While the bricks are only warm to the touch after hou...
How do I remove nuts and bolts that have been rusted together. I have an old bench outside with non-rusting iron frames at each side and old rottin...
I was recently given a Model 100 radial arm saw. It is missing several parts. I can buy many of them online at ***** but not a manual. I would be ...
I was wondering if anyone could tell me where I can find an adapter to change my 1/2" arbor on my Craftsman bench saw (103.23420) to accept a stand...