I have an old table saw 113.29950 with a 220v motor. I am looking for a 110v motor model # 62317 to replace it.
COMMUNITY FORUM: TOOLS & WORKSHOP
I've never installed crown moulding before, but plan to put it in my family room. In searching the web I've seen two ways of handling inside corne...
I'm going to hang a six foot swing on my screened in porch and I think I have a problem. The roof of the porch is slanted, and the 4x8 beam that I'...
The color "espresso" is being used on alot of furniture these days. I can't seem to find this color anywhere. Is this an item blended by the manu...
My husband's objection to moving to the Florida Keys is that all his garage tools would rust. He does have quite a bit of very expensive machinery....
How do you replace the belt on the inside of the motor. Not the sanding belts.
I have 3 dremel general use tools and a dremel contour sander,, they all quit working within a year of purchase, would never buy another.
I have a Sears Craftsman 12 " wood lathe, that has a "dead" tailstock center (doesn't rotate with the stock being turned) and I'm trying to locate ...
Bob, in a recent article you talk about electrostatic filters for the home and how they need to be washed so I went out and purchased some. I want...
I am trying to find the name for a solid wood pry bar(?). They were about six feet long, round except for the last 18 inches which were square. I ...
I just picked up a Craft$man Radial Arm Saw, Model number 103.29310. Does anyone have a repair/parts manual, Schematic drawings and/or an owners m...
I'm building a lattice shade arbor across the front of my house. It is 20 ft wide in the back, attached to the house, and angles out to 24 ft wide ...
Stilhaus Kitchens Con-tinue to beat all prices .Stilhausn Kitchens Con-tinue to offer a pay on delivery service.Stilhaus Kitchens Con-tinue to offe...
BELT CHANGE. Am looking for an easy and safe way to put a new belt on my Sawsmith. The owner's manual does not even broach the subject.
I have an older model 12" Craftsman band saw. I am trying to get it into condition where I can sell it. It runs fine, but the "tire" on both ...
Dear Bob Vila, I need the transmission rubber belt for the jointer/planer 4 1/8" 5/8 HP Sears Craftsman. Please let me know if tis parts are avail...