I am framing in my house. i want some doorways to have arches. How do I go about doing this?
COMMUNITY FORUM: TOOLS & WORKSHOP
What is the best way to make my table saw surface smooth and avoid rusting. Also scrollsaw table surface. What kind of cleaner should be used? Any ...
Does anyone know where I can get the plans for the spiral stairs Bob had on his show?
I am looking for brackets that are installed into the ends of bed rails I am making a 4 poster bed and need to have these to complete the job .. ...
I have a compound miter saw, and I'd liketo put up crown molding. How do I cut crown molding ? I saw a previous post mentioning turningit over, b...
I have recently moved into a 38 year old ranch home in serious need of remodeling. My grandmother lived here before me and allowed the house to bec...
In new construction I am curious as to what is acceptable when it comes to caulking crown molding in the corners as well as on the sides of walls. ...
i was thinking about stripping my kitchen cupboards down and staining them. the house i live in is about 25-30 years old and the cabinets hava many...
I would like to try to repaaint my kitchen cabinets myself, rather than having them completely replaced. They are wood cabinents (but are pretty ch...
FYISee the pro's opinion of Bob at the Fine Homebuilding's BREAKTIME discussion Group:http://www.taunton.com/fh/THREAD:Who thinks Bob Villa is wort...
We are building our own kitchen cabinets, and are now working on eight lazy susans. We've cut circles out of three quarter plywood, and tried gluin...
Would like to know if there is anyplace online that I could get plans with materialslist for a built in pantry ie: 30"x84 withfour doors and slidin...
I, too, am in the market of stipping my kitchen cabinets. The cabinets and drawers seem easy enough to strip because I will be able to remove them...
Is it possible to make cabinet doors (rails and stiles) with a quarter inch bit? If so what bits would they be, and were would one get directions o...
I'm getting ready to put up oak crown molding in my den and I want to do it with my delta contractor table saw. I know that if I were to use a mite...
We're having problems with a belt sander: Craftsmen model #113225900. Despite all effort, adjustments etc. the sanding belt will not stay on uni...
I am confused about air nailers. Do you need to buy the same brand air nails as the tool? Or are the nails interchangable as long as they are the r...
My house was built by my Father in 1954. It has lots of beautiful knoty pine walls and doors. The varnish is dried and cracking in some spots. I wo...
I saw a "floating shelf" advertised in a catalog & want to install a couple of very small ones on one wall w/ 3/4" laminated particle board. What ...