what type of wood should I se and how do I bend it to make sleigh runners?
COMMUNITY FORUM: TOOLS & WORKSHOP
I, too, am in the market of stipping my kitchen cabinets. The cabinets and drawers seem easy enough to strip because I will be able to remove them...
Is it possible to make cabinet doors (rails and stiles) with a quarter inch bit? If so what bits would they be, and were would one get directions o...
I'm getting ready to put up oak crown molding in my den and I want to do it with my delta contractor table saw. I know that if I were to use a mite...
We're having problems with a belt sander: Craftsmen model #113225900. Despite all effort, adjustments etc. the sanding belt will not stay on uni...
I am confused about air nailers. Do you need to buy the same brand air nails as the tool? Or are the nails interchangable as long as they are the r...
My house was built by my Father in 1954. It has lots of beautiful knoty pine walls and doors. The varnish is dried and cracking in some spots. I wo...
I saw a "floating shelf" advertised in a catalog & want to install a couple of very small ones on one wall w/ 3/4" laminated particle board. What ...
Blade deflected off a small work piece. Thereafter the work arbor seems bent. I am unable to square the blade to the table as there is an excursion...
What kind of unfinished wood should I get for a kitchen butcher block? I've hear Maple is best, but its pretty expensive out here on West Coast. ...
i would like to tear down a huge deck off our house. deck is on the second floor. i would like to be able to reuse the material to "move" it to t...
I am looking for plans or patterns for making shutters for exterior windows. I used every search engine available but could not come up with any hi...
Due to limited space, I built a computer monitor desk that is attached to the walls on 2 sides. On these sides it rests on a 2x2 that is bolted in...
I want to clean my kitchen cabinets of the years of grime without stripping and re-staining. Is there any product that will help me do this. I do...
I have a very long blank wall in my living room. This would be the right spot for a wall to wall, floor to celing entertainment center, or base cab...
Planning to replace iron railing with oak railing on inside stairway. Any tips would be appreciated.
I am looking for plans to build a sturdy workbench approx. 6 ft.wide. Any help would be appreciated.
Need to shave off about 1/32nd inch from about 100-200 pencil size objects. Don't owna lathe but have drillpress and must be perfectly round so can...
I afraid if I just "screw" my catalog glides to my table top, the slightest racking will pull them out or something worse. Should I use some mediat...
I returned home on the 1st of the year to 4 1/2 feet of water in my basement. This covered my workbench and was drownding my tools. My bench grin...