I am renting a house that has a great fireplace but no mantle. Any Ideas for Stockings without drilling a bunch of wholes on the Brick wall?
COMMUNITY FORUM: TOOLS & WORKSHOP
There seem to be a lot of positive reviews about Simple Strip/ Wallwik wallpaper removal system. Has anyone tried it personally and would you reco...
I need a copy of the manual for my Tool Shop 10" sliding compound mitre saw model #240-2094. I am having issues with the way the guard goes back t...
This tool appears at 15 seconds into the video, but it's not identified: http://www.bobvila.com/articles/repairing-hardwood-floors/ I need to...
Where can I get a key for this saw or a picture of one so that I can make it myself.
I need tires for both wheels that measure 13 7/8 and are 1" wide. Any information on possible suppliers would be extremely helpful. Thanks, Emma...
I currently own a Duracraft bench Bandsaw Model #20412. I'm looking for a replacement for the drive pulley off the motor (5 7/8") width. Any idea...
I have discovered a potential design flaw in the motor start capacitor switch on the 6 Hp vertical 30 gallon Crafstman compressor model 919.167310....
Hello, I purchased a used Craftsman Router #315.17461 and was wondering where I could obtain an instruction/owner manual for this. Thank you
need the manual for this sander or detail instructions on how to change the belt. Actually, I just need to know how to properly straighten out the ...
Just bought this Craftsman Jointer model # 149.21871 at our local flea market. $8.- !!! I'll have to set it up and use one of the other motors...
Hello, I have been looking for this service and I found this site as one of the best. Has anyone have looked into this before? I heard that http:/...
I am doing an addition on my home and I am shopping the lumber list given to me by my framer. I was asked today what I want the list priced out wit...
i am looking to make and mount a wooden headboard to a king size bed. i am wondering what type of material should i use, i.e. wood post or metal, ...
I have taken up carpet and thinking about renting a sander to sand the old, bad condition hardwood floors, any suggestions would be helpful.
My home, built in 1925, has beautiful hardwood floors, I think pine, but I'm not too certain. I don't know my wood really well (take that how you w...
I recently bought a house and the hardwood floors are painted. I was wondering if anyone has tried removing paint from hardwood floors and if it's ...
Anyone know where I may get lucky and locate this item?(No longer available from sears)
I have a model number 137.248830 Craftsman 10" table saw and need a used or reconditioned motor, part number OQEF.