Hello, I purchased a used Craftsman Router #315.17461 and was wondering where I could obtain an instruction/owner manual for this. Thank you
COMMUNITY FORUM: TOOLS & WORKSHOP
need the manual for this sander or detail instructions on how to change the belt. Actually, I just need to know how to properly straighten out the ...
Just bought this Craftsman Jointer model # 149.21871 at our local flea market. $8.- !!! I'll have to set it up and use one of the other motors...
Hello, I have been looking for this service and I found this site as one of the best. Has anyone have looked into this before? I heard that http:/...
I am doing an addition on my home and I am shopping the lumber list given to me by my framer. I was asked today what I want the list priced out wit...
i am looking to make and mount a wooden headboard to a king size bed. i am wondering what type of material should i use, i.e. wood post or metal, ...
I have taken up carpet and thinking about renting a sander to sand the old, bad condition hardwood floors, any suggestions would be helpful.
My home, built in 1925, has beautiful hardwood floors, I think pine, but I'm not too certain. I don't know my wood really well (take that how you w...
I recently bought a house and the hardwood floors are painted. I was wondering if anyone has tried removing paint from hardwood floors and if it's ...
Anyone know where I may get lucky and locate this item?(No longer available from sears)
I have a model number 137.248830 Craftsman 10" table saw and need a used or reconditioned motor, part number OQEF.
I have mixed the charger in with a box of other wall chargers. Does anyone know what input/output voltage and amperage is supposed to be for this ...
HELP!!!!!!!!!!great website - need help deseparately - i have a dining room table and two end tables and a cabinet - that are very old but very stu...
Hello guys. I'm a newcomer here and I have this terrible problem at my kitchen pipe. The pipe plug seems not to be working anymore now as I ...http...
The auger stopped turning. The shear pins are intact. The impeller turns fine. Any thoughts what it might be before I open the gear box?
My window and door frames are old and beat up. I don't want to paint them b/c I'd like the wood to show. What is the best technique for refinishing...
Need a parts manual and owners manual for a Rockwell/Delta 34-600 9" table saw. In fact any information anyone has on this saw I would appreciate....
I have a 19?? Wayne Air Compressor Model 376V (AC4120). The unit stills runs but it is a little slow filling the tank up. I have researched Wayne ...