with no prior experience, i would like to refinish some inside wooded doors i.e bathroom, bedroom doors. They are scratched and a cpl of them have ...
COMMUNITY FORUM: WINDOWS & DOORS
Do I need to "frame" an opening to install folding doors, or simply install a track?
We need to replace the door knobs in the house we just bought. One of them has a plate at the base that you can pry loose but not off. The screws...
I have a 6 yr old Craftsman 1/2 HP opener. When it gets cold (<20F) it will not close the door. It starts and then reverses. This is the firs...
Hey There, Hoping one of you garage door guru's out there can help. I have a Craftstman 1/2 HP garage door opener that is somewhere between 3-5 ...
anyone know how to replace a single pain of glass in an old french door? in looking at it, there doesn't seem an easy way to do it. it's not like ...
I have lived in my condo for 20 years. Last week i noticed a film between the panes of one of my floor to ceiling windows. What can be done to corr...
I have a 5 year old Sears Craftsman garage door with a remote that has a few extra buttons. My brother also has the same. It is my understanding ...
Just had my entire house remodeled & it all started because there was a window beside the tub that kept rotting out. This time we were going to pl...
i am redoing a mobile home and one of the bedrooms has a slide door, the kind that goes into the wall, i want to use a prehung if i can but never h...
I have a craftsman garage door opener, and I changed the light bulb in it today because it had burned out. Following installation of the new bulb,...
I am looking for a Garden Window for a kitchen that meets the vigorous code for hurricanes in Florida. I understand it has to withstand 100mph wind...
Hi! Can anyone help? I have an older (approx 9yrs old) Sears Craftsman 1/2 HP chain garage door opener. It sticks when going up in the cold weather...
I would like to install bifold doors. the standard width for the doors is 48". I measured the actual width in the frame and it appears to be only...
I have a broken garage door window. It is a metal door. I can't seem to be able to separate the vinyl(?) inner part of the window frame from the ...
I need to replace the deadbolt portion of my front door handle. There is a panel on the inside portion of the door that needs to come off but I ca...
my molding on my door doesnot fit due too the door casing being set in 1/2 less then the walls do i cut back the drywall too gain the angle or add ...
I am replacing my windows. The labor quote is $100/hour ($1400 for 2 men, 1 day). What is a reasonable rate for labor on this type of job?
I have some double pain windows that have some sort of film between the pains. Is there any way to remove this film?