We need to replace the door knobs in the house we just bought. One of them has a plate at the base that you can pry loose but not off. The screws...
COMMUNITY FORUM: WINDOWS & DOORS
I have a 6 yr old Craftsman 1/2 HP opener. When it gets cold (<20F) it will not close the door. It starts and then reverses. This is the firs...
Hey There, Hoping one of you garage door guru's out there can help. I have a Craftstman 1/2 HP garage door opener that is somewhere between 3-5 ...
anyone know how to replace a single pain of glass in an old french door? in looking at it, there doesn't seem an easy way to do it. it's not like ...
I have lived in my condo for 20 years. Last week i noticed a film between the panes of one of my floor to ceiling windows. What can be done to corr...
I have a 5 year old Sears Craftsman garage door with a remote that has a few extra buttons. My brother also has the same. It is my understanding ...
Just had my entire house remodeled & it all started because there was a window beside the tub that kept rotting out. This time we were going to pl...
i am redoing a mobile home and one of the bedrooms has a slide door, the kind that goes into the wall, i want to use a prehung if i can but never h...
I have a craftsman garage door opener, and I changed the light bulb in it today because it had burned out. Following installation of the new bulb,...
I am looking for a Garden Window for a kitchen that meets the vigorous code for hurricanes in Florida. I understand it has to withstand 100mph wind...
Hi! Can anyone help? I have an older (approx 9yrs old) Sears Craftsman 1/2 HP chain garage door opener. It sticks when going up in the cold weather...
I have a broken garage door window. It is a metal door. I can't seem to be able to separate the vinyl(?) inner part of the window frame from the ...
I need to replace the deadbolt portion of my front door handle. There is a panel on the inside portion of the door that needs to come off but I ca...
my molding on my door doesnot fit due too the door casing being set in 1/2 less then the walls do i cut back the drywall too gain the angle or add ...
I am replacing my windows. The labor quote is $100/hour ($1400 for 2 men, 1 day). What is a reasonable rate for labor on this type of job?
I have some double pain windows that have some sort of film between the pains. Is there any way to remove this film?
Is a belt drive garage door opener better than a screw drive or chain drive? I know the belt drive will be quieter, but I am looking for long term...
Hi all, I am not sure if this is the right place to post this. I purchased a vehicle that had been spray painted. Most of the paint came off ea...
the bottom half of one of my sliding glass patio doors is severely scratched from the continuous scratching by a large dog--is there any way of rem...