Flourescent light switch arcing; breaker tripping
Greetings :-)A couple of years ago, I installed a flourescent ceiling light fixture (4x40W), using 3-way switches. Recently, one switch started arcing occasional...
Greetings :-)A couple of years ago, I installed a flourescent ceiling light fixture (4x40W), using 3-way switches. Recently, one switch started arcing occasional...
0
answersI have 2 deep cigarette burns on my oak coffee table. Does anyone know how I would repair this by myself? Any help is greatly appreciated.Thanks
1
answersI have read enough messages to know that hardwood can neither be glued or nailed to paticle board but want to know if I can fasten 1/4" plywood over the particle ...
1
answersI have a ***** 625.341942 automatic resin cleaner on my 625.340700 High Capacity 70 water softener. I am going to replace the water softener with a 625.388260 Ul...
0
answersI'm thinking of putting in floor tiles in the entry and bathrooms of a house that's being built as a rental in an up-scale area. The house is built on a concrete ...
2
answersDo you always have to use thin set to mount a backer board to the floor? What will happen if you dont?
1
answersHi! I just removed the carpet in my bedroom and the floor is full of spatters, especially around the baseboards where they seem to have used the cat's tail instea...
7
answersI have a 20x24 family rm with very old natural barnboard walls. I would like to paint (not spray) the walls . With the boards being so porous, what would one r...
1
answersHi all, our manual trane heat pump thermostat is going out. We'd like to replace with one of the aftermarket programmable thermostats, but Trane's lettering schme...
0
answersMy latex primer and paint do not seem to be sticking to my pressed wood book case. Am I going to have to remove paint and primer and redo with an oil based paint...
0
answersWe're having a screen room built on the back of our house. Even though the deck boards will be put down as close and flush as possible, our contractor will be in...
2
answersI just bought a very rusty antique iron bed. I was just wondering how I should go about restoring it. I have been previously told to sand blast it then seal it wi...
0
answersHello,I want to install a bamboo floor in my living room, dining room, breakfast nook and stairs. What I have read so far says I need to lay the boards perpendic...
1
answersWe are building an island in the kitchen of our new house. One side will have bar stools and the other side will either have a sink or we could put the range or ...
3
answersHelp! I have just acquired a home that has been in my family for generations. In the basement of the home the foundation is cracking all four walls have cracks in...
0
answersI have a 12" x 12" register that doesn't have any insulation in the box. What's the right type of insulation to use and where might I get it?Also interested in a ...
1
answersWe have recently purchased an older home. We want to tear up the old carpet and refinish the wood flooring underneath. The carpet is 30 years old (at least) and...
4
answersI am considering the purchase of a 1 story 1962 home that has ducts that are in very poor condition according to my inspector.He claims when the heater is in use,...
1
answersi hope there is someone out there that can help me...i am trying to redo my mothers dining room which is in severe need of remodeling, as i see it, my fist step i...
2
answersAny tips about install hard wood floor (solid, 3/4", strip) in the powder room? It has venyl sheet currently. Since wood floor and venyl sheet have diffferent thi...
3
answers