Updating bathroom wiring
I'm working on remodeling a bathroom in a house built around 1976. I found the 15 amp circuit feeding the plugs and light in the bathroom is coming from a plu...
I'm working on remodeling a bathroom in a house built around 1976. I found the 15 amp circuit feeding the plugs and light in the bathroom is coming from a plu...
2
answersHow do you keep dark shadows from appearing on walls where an electric baseboard heater is located?
0
answersI am doing a small shed attached to a building. I'd like to know where i could find info on how to use a speed square to cut the roof rafters. TY
2
answersI am looking for information on the difficulty of rebuiling my chimney from the roof line up. The previous owner had a leak in the roof around the chimney and cho...
1
answersDo you have CFI basement and what is your opinion of cost and installation? Do you know of anyone in northern Missouri that does a professional job on a home bas...
1
answersMy husband and I are first-time home buyers, and the home we are buying has baseboard electric. We want to replace it with forced air (heating and cooling, it ha...
0
answersTrying to strip 50 yrs worth of paint off. The prob is , nics/gouges with old paint in them..etc in the baseboard,after stripping & flat sanding. How to get ...
0
answersHello!I'm trying to build a bathroom in my basement. I started digging a hole for the standard 30" sewage basin, but I found water at 19". (I don't think I want t...
1
answersWhat advice can you give re painting plywood floors to use for a couple of years instead of laying down flooring?
1
answersI have a three way switch circuit hooked up and it seems to work fine. There is only one problem. Occasionaly when you hit the switches there is a little cracklin...
0
answersI need to cut a few inches off the end of a countertop. The countertop has an integral backsplash. I have a hollow ground circ saw blade and a laminate jigsaw bla...
5
answersI am the proud new parent of a pancake compressor, a finish nailer and a really nifty compound miter saw.I am no pro that for sure but I’m not a total moron. I h...
3
answersPosted yesterday on same subject, but without the icon. ANY suggestions or ideas most gratefully accepted.
0
answersI have an invention and need help on marketing and obtaining a patent with little or no money.........[This message has been edited by alabama electrician (e...
0
answershi all, I'm a finish carpenter that's self taught. My question is regarding over the post stair rails. I do the trim work for a builder in my area and about 15% o...
0
answersDo you know of any contractors that build a post and beam home, also if you have had one built anywhere in the use what company did you use and suggestions on the...
0
answersWe are going to build on a lake lot in Northern Missouri and would like any suggestions on geo thermo heating and spetic systems used in Missouri or trusted deale...
0
answersDoes anyone have any advice on how to paint outdoor retaining wall blocks and outdoor concrete flooring?We are going to paint a basketball court on our outdoor co...
0
answersThe house I own was built in 1972. The wiring system installed inside the walls is 1/2 flex cable with two 12 gauge wires, no ground wire. The flex cable itself i...
1
answersI live in a house that was built just 6 years ago. One of my outlets stopped working yesterday for no apparent reason. I replaced the outlet itself and still no...
1
answers