My friend has a 2-3 year old ,never been assembled, Smart Gardeners Workshop. He now needs to sell it,but can't find the Manual for this, #15114. ...
G'Day All, I have recently moved to Alberta Canada from Australia and I have never seen snow like we have been getting lately. Anyhow I have ...
I have opened the spa cover after four months and I found out there are a lot of mildew and bad odors on the cover. The spa cover is not so old eno...
I am looking for 3 boxes(50sq feet) of Maui ceramic tile 12x12 to finish my project. I will pay to ship them to Chicago area.
Please help! Have to finish job already started. Would like to buy 2 boxes. Please e-mail at [email protected] Pergo Presto Red Oak Bl...
I have a 15 amp GFCI outlet in a master bath, the circuit breaker for the bathroom is 15 amp. Can I plug a 1875W hairdryer into the lone GFCI outle...
I have a stove from a house it was rated at 50A I bought a mobile home with a double 30A breaker. can I use the stove on this 30A if I change the p...
I am in a situation and need help quickly. This is urgent. I have had continual problems with Home Performance Alliance, Inc. It has been very f...
How do I get faded vinyl siding looking good again, Pressure washing didn't do much is there a cleaner or restore out THERE???
My 3ft wall between properties is beginning to sag. Is there a company that will do repairs in the Scarborough On area?
I'm looking to put floor heating in my bathroom and i'm trying to decide between using Sun Touch OR Warm Up? Does anyone know which company is bett...
Hello... I "think" I have gone thru all the posts I could find on this subject but I haven't found what I need. I just yesterday got a dbl.doo...
Does anyone know how or where I could find Armstrong rosedale pattern vinyl floor tiles. 24876?
Our foundation has sunk on one side because of poor drainage. As a consequence our floors tilt, about 3 inches lower on the bottom end of the tilt....
I glaze coated a bar top and had to wet sand it down a little bit to remove some surface imperfections. Sanding it left the surface very hazy. Wi...
Renovating - these cabinets need a good home. Some rust but nothing a little elbow grease and metal paint cannot fix. 8 Pieces in all. Handles are ...
I painted a cupboard and now I cannot get the doors to line up to shut. What do I do?
How do I make a clean cut to my vinyl plank to fit over sink water pipes?