Is it possible to paint veneer?If so, what kind of paint do i need ?Thank YouBob
need to replace deadbolt lock but screws cant be unscrewed. Door is wooden, very old, half glass, oversized & expensive to replace. Any way to ta...
the floor of my beach house on stilts is being insulated, what kind of sheating should i use to cover the underside with?
RECENTLY I AM HAVING MY BASEMENT FINISHED, BUT DUE TO A POSSIBLE WATER PROBLEM THAT MAY ARISE WE HAD TO PUT DOWN A FALSE FLOOR & TWO SUMP PUMPS, WH...
I have two storm doors which were slung open by gusty winds and ripped the door piston right out of the jam. I cannot reattach them now because a ...
is there any kind of "rule of thumb" that says basement doors/trim should/must be the same color as rest of house? we want to put white, 6-panel d...
I would like to open a kitchen wall to make a breakfast bar. Can anyone give me some tips?
What is the best way to make my table saw surface smooth and avoid rusting. Also scrollsaw table surface. What kind of cleaner should be used? Any ...
My paint is peeling around the registers in my house, usually during colder weather when the heat is blowing through the registers. Is there anythi...
I have a relatively new 10' saw which, after making a single cut, would not start again. I have not blown a house fuse, and there is no fuse built ...
Ok, have the roof all pressured cleaned and ready to be sealed. Originally I was going to seal it with KoolSeal, now I'm hearing good and bad thin...
I have a gutter that drains between the concrete patio up to the house and the driveway. When it rains water stands in that area at the corner of t...
I have a gutter that drains between the concrete patio up to the house and the driveway. When it rains water stands in that area at the corner of ...
In the corners, around doors and windows I have notice cracks. Some are bigger than others. Is the a fill I can use for long term coverage withou...
I've noticed that my hardwood flooring in spots are begining to separate as much as 1/8" and its in a very noticable area. I've put a rug over it f...
I have a section of hardwood boards that are rising up about an 1/8". The boards are above a main support beam. How do I smooth out or flatten the...
How can I remove an old linoleum floor carpet from the 40's (?) and move it to another home. Beautiful condition/hate to see it thrown away. Hear...
I have a craftsman dovetail jig... I must be doing something wrong. Too Loose, plus I don't know if I'm using the jig correctly