Need instructions for fixing Craftsman table saw. Relay/capacitor/...good. Windings good...must not be connected right. Any schematics available...
Hello,My name is Daniel, and i have been thinking about building my own home,in Maine, for some time now and every time I inquire about what docume...
Hello,My husband and I are about to break ground on our first home. Being a novice at any type of home experience I'm a little concerned about some...
Our house is 26 years old. We moved in 4 years ago and had the 1st and 2nd hardwood floors refinished. About 1 year later the floors started to s...
we have painted our front deck (uncovered) white to match our home. however the white is so bright that you have to shield your eyes from the glare...
i need instructions or a diagram for"wiring"a 240 volt 5 hp Craftsman air compressor from my shop to the service pole. Also is there anywhere I can...
In the Winter, it is very windy where we live. On the side of our house that faces the wind, the vinyl siding creaks. Many times it creaks loud e...
What is the name and where can i find a drill bit that drills a square hole (i seen Bob use one)
We have a squeaky floor in the kitchen. The house is about 15 years old and in the winter time the floor squeaks in certain spots. The plywood was...
Our zebra-wood dining table's poly finish is dull in several spots. Is there a safe way to restore the uniform high gloss it once had?
I have a concreate slab porch (not attached to the house). The slab has sunk and cracked in the middle, forcing up both ends. What is the best m...
while upgrading a wall, I am relocating the switch. The line in the wall is too short. I plan to place a junction box at the end of the existing li...
I cannot get the bit out of my router to change it. The thing just won't turn. Any ideas?
I purchased pre-formed laminate countertops for our kitchen and am about ready to begin installation. The only area I'm unsure of is the right met...
I recently purchased a new home and have begun renovating the basement I have discovered that a switch a 3 way switch has been wired incorrectly it...
Last spring I had two 8 foot flourescent double tube fixtures added to an existing circuit with two 100 watt regular light bulbs and 1 four foot fl...