I have an area at the entrance to a room with oak flooring where the flooring strips aren't tight against one another. This has apparently happened...
Is there a product, similar to z-brick that I can install on the face of my fireplace? I'd love something that looked like flagstone but didn't hav...
The faucet for the washer & dryer is leakyand needs to be replaced. In trying toremove them, it appears to be soldered on.Is this common? Hold do...
How do I go about finding & installing doors that slide-in on an entertainment center? Any ideas? Thanks!
I need help. I've purchased a couple of differant brands of 3/4 inch pipe clamps and various pieces of 3/4 threaded pipe and I cant come up with a ...
I have a door which is an old garage door, or half of one. It is 44"Wx90"H. What is the best way to install this in a construction setting which wi...
I've got a 16x7 steel garage door. One of the torsion springs broke, I replaced both springs. What is the approximate amount of revolutions should ...
Any opinions on putting fiberglass batts on the underside of the roof (between the rafters) to improve insulation? Have seen it done on a show or ...
I have a heater in my non-insulated garage and would like blown in insulation. Do I need a vapor barrier? and is there something out there that...
I have finished sanding, put down wood conditioner and stained a new unfinished pine dresser. My problem is that when the stain was wiped off I sa...
My kitchen cabinets have a space built in for the refrigerator but the space isn't big enough for the type of fridge I want to buy. There is a smal...
I have a 25 year old dining room table that needs a new finish. It is a inlaid wood pattern that was probaly stained and varnished but over the ye...
Has anyone ever heard of an outlet like this one that I encountered? It has the 2 hot wires and the 2 neutrals hooked on the side bolts and there ...
Heat Exchange Tank has a serious leak. Can I bypass that system with a Large Water heater and us the circulation pump, demand, and safty features ...
I am building a rec room, I will attempt to install 2 heat vents. I say attempt because I have never done any HVAC. I was wondering if it is necess...
I receiently installed a 130000 BTU boiler in my home about 2 years ago.Latly Ive noticed the system pressure running very close to 30 psi when...
Does anyone have a quick rule of thumb equation for the number of btu's per sq. ft. needed to heat a home? Thanks for any help.
We just bought an old house that had an addition put on after it was built. The heating system is radiant. Well there is no radiator in the additio...
The concrete floor in my basement is flaking, dusting, just plain deteriorated. A bad mix is my guess. Someone along the way tried to skim coat it ...