I have run a switch loop with 2 simple incandescent fixtures with a single pole switch at the end of the cable run (pwr. in----fixture----fixture--...
Just wanted some feedback on a situation that I am currently faced with... House built = 1927; Trees surrounding main sewer line = yes, 50ft elms; ...
When installing tongue and groove pine board and it is necessary to pre drill the nail holes in the tongues, could this step be skipped if using a ...
Any help on tools or techniques to take subfloor from kitchen around cabinets. Putting in a hardwood floor and must take off subfloor.
Hi, the walls and ceilings in my home have lots of nail pops which I have to do something about to refinish the walls nicely. I am wondering a coup...
I'm putting in a new driveway and have decided on cement or brick---i prefer the way brick looks. My questions are about durability---brick vs. cem...
Basement bathroom has already been stubbed, plumbing to bath, sink, and tub is complete.Question:The toilet exit line is a 3" PVC coming out of the...
I am building a low profile 16'x32' deck and I have to fasten 30 pressure treated 2x4's, wide side down, to a concrete slab. I would prefer not to ...
I am creating a 4x8 bulletin board using homosote covered in fabric. I have been advised to spray the homosote with an adhesive prior to covering ...
O.K. I decided not to add any subfloor. My basement floor currently has the stick down squares. Can carpet be added over it?? I am moving walls ...
When we installed a new roof this past month, we put the weathershield over the gutter hangers. Should we have pulled the hangars off and put the ...
The title says it all. My Craftman 1/2 HP GD opener works, but only when I turn off the ignition of my Jeep. When I back out of the garage, I tur...
Help. I have very bad sweating of all my windows and even some sweat on the ceiling where the wall meets. We are talking a lot of water on the wi...
If anyone has any information on installing a 'zero clearance', ventless gas fireplace please pass it on. I'm looking to heat my finished basement...
Hello,I will be finishing my basement this winter and have been told that a subfloor would make for a much more resilient surface for installing ca...
I want to know the difference in regular & marine plywood and what should I expect to pay for the marine plywood?