I need a cast stone manufacture for a fireplace I am building in a house. Also, crushed and recast limestone is a possiblity.
I have a concrete slab garage floor. Since I do a lot of work on my cars I would like to cover the floor with some kind of paint/treatment that wi...
i want to learn how to calculate and build stairs with the treads and risers routered into the stringers. i already have the "rosendahl's" books an...
i want to learn how to calculate and build stairs that have the treads and risers routered into the stringers.
Im looking for a CRANE Crieton style toilet seat. This is the old Saddle Seat style. We are looking for pink, but will consider any color. The name...
Im trying to fine a Crane Criteon style toilet seat. This is the OLD saddle seat style....We want a new one in pink but will consider any color. Or...
Previous homeowner used liqued nails to glue mirrors on a painted plaster wall. The only way I know to remove them is to smash them with hammer an...
I recently had a couple large tree stumps removed, including digging out surface rootsto a depth of 2 - 2.5 feet, and out to 15feet from the stumps...
My very old Coleman floor furnace has died! Am searching for manufacturers of floor furnaces. Can anyone help?
I am framing in my house. i want some doorways to have arches. How do I go about doing this?
need to replace deadbolt lock but screws cant be unscrewed. Door is wooden, very old, half glass, oversized & expensive to replace. Any way to ta...
the floor of my beach house on stilts is being insulated, what kind of sheating should i use to cover the underside with?
RECENTLY I AM HAVING MY BASEMENT FINISHED, BUT DUE TO A POSSIBLE WATER PROBLEM THAT MAY ARISE WE HAD TO PUT DOWN A FALSE FLOOR & TWO SUMP PUMPS, WH...
I have two storm doors which were slung open by gusty winds and ripped the door piston right out of the jam. I cannot reattach them now because a ...
is there any kind of "rule of thumb" that says basement doors/trim should/must be the same color as rest of house? we want to put white, 6-panel d...
I would like to open a kitchen wall to make a breakfast bar. Can anyone give me some tips?
What is the best way to make my table saw surface smooth and avoid rusting. Also scrollsaw table surface. What kind of cleaner should be used? Any ...
My paint is peeling around the registers in my house, usually during colder weather when the heat is blowing through the registers. Is there anythi...
I have a relatively new 10' saw which, after making a single cut, would not start again. I have not blown a house fuse, and there is no fuse built ...