Attic insulation?
I recently purchased a 1960 ranch with an attic that has about 3-6" of batt insulation with vapor barrier...2x6 rafters where some of the insulation has been comp...
I recently purchased a 1960 ranch with an attic that has about 3-6" of batt insulation with vapor barrier...2x6 rafters where some of the insulation has been comp...
0
answersI recently purchased a 1960 ranch with an attic that has about 3-6" of batt insulation with vapor barrier...2x6 rafters where some of the insulation has been comp...
0
answersWe have a leak in our living room. It actually started at the top of the window ceil. We though since the windows were old if we are replaced them it would fix ...
1
answersIn a basement bathroom on a concrete floor should I set the cabinets before I tile or after? Thanks
2
answersThe previous home owner installed a utility room (washer/dryer) and half bath in the back addition of my house. Water plumbing is run through the back exterior w...
0
answersI have a weslock door latch that failed. I have gone to three hardware stores and can not find a latch as short as this one. I don't want to replace the whole m...
0
answersI have to replace a partial floor in an old victorian home built in early 1900's.The old floor is 7/8" thick and 2.25" wide maple. The room is about 11" long and ...
2
answersI have read through many topics here covering insulation types for an older house, but I am looking for specific recommendations or experiences. I have a 1928 bal...
0
answersI had copper gutters installed a fews years ago. They look great, but tend to leak at the seams. Does anyone have experience re-soldering seams? Do I need to r...
1
answersWhen I think I'm getting close to a decision, there is always another question. Can anyone give me information on experience with Weathershield or Proshield or v...
0
answershi all, the question is or actually the plan is:I am installing florescent undercabinet lighting. The plan is to wire the outlets that these lights will plug int...
2
answersI recently used a moss killer to kill moss that was growing in between the pavers that make up my front walk. In so doing, the chemical stained the pavers yellow....
0
answersLooking for the model number for craftsman 1/2" drill stand (same one as in current craftsman catalog). ***** no help.
0
answersWe are renovating and trying to match the existing ceiling. It has sort of a leaf design or maybe I should describe it as veins of a leaf. We haven't been able ...
1
answersThe flooring guy at ***** said we could just glue down our Bruce hardwood floor right to the concrete. But every article I have read about on here said to instal...
9
answersMy daughter recently bought a DATED house from the 70's with an orange ceramice tile/dark brown grouted foyer.Is it possible to PAINT the grout and if so, how do ...
0
answersWhere can I purchase friction catches for Saint Charles kitchen cabinets?
0
answersI have two walls in my spare (computer) room that are cork board squares from ceiling to chair rail. I really like these and use them quite a bit. However, they...
1
answersI want to use mirrors as a backsplash for my countertop range. Are mirrors safe to use? Are they heat resistant?
2
answersI am in the process of constructing my 2 story house. The dimensions are 30x44. I am using 5/12 trusses with a 12" overhand on 16" centers and 5/8" Sheating. W...
2
answers