B&S Mower Stalling
Hello: I have a 22inch standard 5.0hp lawn mower. After about ten minutes running, the engine begins to idle high, then low, then high, then low, until the engi...
Hello: I have a 22inch standard 5.0hp lawn mower. After about ten minutes running, the engine begins to idle high, then low, then high, then low, until the engi...
4
answersI have a Campbell Hausfeld 1750 psi pressure washer. Works fine but you can only use soap at low pressure setting because the detergent injector is on the dischar...
2
answersSorry to sound so dumb, but I need to order a 7mm and an 8mm open end wrench to work on my Vespa. The tools are available in 6pt and 12pt, but I don't know what ...
2
answersI would like to change a outlet in my kitchen from a two outlets receptacle to a 4 outlets receptacle. Is this possible and how would I go about it? Note! I will ...
2
answersI am looking to install PVC Railing on my front porch that has a roof overhang. There was a wrought iron railing previously, with a single support rail for the ov...
0
answersI AM GETTING READY TO PAINT OVER A TEXTURED CEILING. I HAVE HEARD TEN DIFFERENT HORROR STORIES ON DOING THIS. WHAT IS THE BEST METHOD FOR REPAINTING A POPCORN C...
3
answersI recently bought a log splitter at a yard sale. It is the kind that has a large cone type cutter on the front that rotates and slowly cuts into the wood. I can'...
1
answersThe bathroom fan is an old Nutone and does not work. I can't seems to find a replace. What are some suggestion to replace the fan?
2
answersI recently bought a house. The condesor is more than enough for the house, however, the upstair does not get cool. What is the problem and what can I do it fix it...
2
answersI just finished doing a straight walkway using the herringbone pattern. It came out so good that I plan on doing it on the other side of the house. The only prob...
1
answersWe are putting in a new septic and it's location might require us to move the pipe exiting the house higher by about a foot to get the required pitch. Assuming t...
2
answersMy wife and I painted our bathrool with Latex Paint. The paint started to peel so we found out it must have been an oil base underneath. To fix the problem we pee...
1
answersI just added a room on the back of my house and I suspect that the copper fhashing is not installed properly because it leaks in that area of the valley during a ...
2
answersMy deck is about 8 years old and was never treated or cleaned by the previous homeowner. I hired a contractor to replace all of the surface boards (5/4 X 6) with...
1
answersI purchased a home 5-yrs. ago and the previous owner did not have the code for the keyless entry pad for the garage door.The pad is a Stanley Digital Entry Pad (1...
2
answersThe cupboards in the kitchen have contact paper on them, removed contact paper, but it has a sticky film on the wood. What should I use to remove the film without...
1
answersI have a small older house with about 12" of blown in attic insulation. This is great for the heating bill, but presents some problems. I would like to remove a...
0
answersI have the panel, hollow core, interior doors. There is a punched in spot right next to the door handle. It is just cracked in to spots, but the one crack goes ...
0
answersi have a kenmore side by side with the ice and water dispenser in the door. the ice maker quits dumping the ice from the freezing tray to the ice bin. if i pull t...
1
answersThe water press coming into my home is high, so untill I a can add a PRV I turned the main shutoff back to restrict flow.When the toilet is flushed, there is a si...
1
answers