Tankless Hot Water Heater
I bought a tankless hot water heater. On the box it says Fantastique and it says Model JCE40. On the heater itself it says JC1. We just hooked it up, and are havi...
I bought a tankless hot water heater. On the box it says Fantastique and it says Model JCE40. On the heater itself it says JC1. We just hooked it up, and are havi...
0
answersI have a couple of problems with my electric baseboard heater...first, it often gets a noisy clicking noise. this happens when i lower the thermostat. I've had to...
0
answersHello,I've found the crown molding I want to use. I can get it either MDF (which comes pre-primed) or pine. I am going to paint it white. The MDF is about half...
1
answersI need to purchase a basic set of sockets for basic auto maint. Do I need to buy more than just a set of 3/8 drive sockets?Do I need both metric and SAE? I figure...
4
answersI recently purchased a child's toy whose battery panel on back is fastened with a screw. When I went unfasten the screw to put in new batteries, the screw merely...
3
answersHi,I just purchased a new house. The cabinets are made out of Oak. They are unstained and appear to have a few coats of polyurathane (sp??). They were not rout...
1
answersI have removed the old tile from my kitchen floor. I want to paint the concrete floor is there any way I can just paint over the asphalt.
1
answersI just recently purchased a house. I was under the impression from the realestate ad that it had pergo flooring...but I was wrong. The person used Shaw laminate...
0
answersI'm begging to think about finishing the basement in our 2-year old home. Unfortunately, the builder wasn't very kind in the finish work with respect to the duct...
0
answersI am just about to begin installing a backup sump pump to my existing sump pump. How hard is the installation? I need to know the difficulty level, so I can cal...
1
answersMy submersible sump pump seems to be moving around in the pit thus causing the float to stick on the pit wall; how can I remedy this problem?
1
answersI am replacing a bunch (all) of baseboards in my home. Most of the outside corners are rounded. I understand making a small piece w/ 22.5 degree cuts to go arou...
3
answersMy submersible sump pump seems to be moving around in the pit thus causing the float to stick on the pit wall; how can I remedy this problem?
0
answersI am remodeling our bathroom. The tile above the tub was installed about 1980. I was told the best way to remove the old tile is to use heat. I did a trial run an...
0
answersOur kitchen faucet normally has excellent water pressure. However, of late, it has dwindled to 50% of normal pressure. If our water has been off for any reason, w...
1
answersHello. I am looking to purchase a band saw to cut cork to make duck decoys. I need a saw that will accomodate blocks of cork up to 8 inches in depth. Can anyon...
0
answersI have totally rewired an old house. Before I started I had an electrician put in a new 200 amp breaker box outside then I went to get my permit to do the rest m...
5
answersI want to install a drop ceiling in my basement.my basement is 7 feet tall,there is no problem installing it here, but my heating duct and cold air return run rit...
1
answersmy uncle told me to get the studs in the basement 3&1/2" out from the wall so I can double insulate it. one going crossways and the other up/down. will this h...
0
answers