A rat came in through my exterior vent and died somewhere in the back of my dryer. The expert I consulted says that the rat likely was chopped up ...
COMMUNITY FORUM: MISCELLANEOUS
Looking to Buy wall mounted Geneva Metal cabinets vintage c. 1950s. Please send photos and dimensions, if available. With thanks and kind reg...
There seem to be a lot of positive reviews about Simple Strip/ Wallwik wallpaper removal system. Has anyone tried it personally and would you reco...
Hi, I have just bought a Challenger CH 1000 garage door opener which has come without any fitting instructions Has anyone got some instruction...
Have a concrete bulkhead stairway that was attached to the foundation by thru bolt & nut. My guess is that this was done just to hold in place unti...
I would like to get rid of a tree stump that is starting to rot and is just a couple feet from the house, I guess mainly because I'm afraid it will...
Hello! I am new here.Going crazy trying to lay a runner on my old stairway. It curves on the bottom and there are three pie shaped stairs. Has anyo...
Looking for case of pergo presto red oak 8mm. Will pay to ship too. Thanks. Marti@sandbassociates.com 541-760-5996
Hi, I'm building my new home and wanted to install multiple LED downlights in the living, dining and kitchen. The builder wants to charge $200 per...
I'm looking to purchase 14 new boards of Pergo Prodigy Antique Amber Oak Laminate Flooring
I just bought a 100 year old house and stripped off about 5 layers of wallpaper. The walls are plaster and lathe, and not in terrible condition so ...
I have 5 unopened boxes of Pergo Signature American Cottage Revere Oak flooring available. Selling for $100 per box. See craiglist post at http://...
I live in a building that was built circa the late 1930s. All the radiators in the building are cast iron radiators from ARCO (which I'm guessing ...
During door installation we. Cracked a few tiles ......I need some Lanzi cactus 13x13.....any idea wherei might find some
I have a 603 sq foot apartment in nyc The contractor wants to skim, sand and paint the apartment for $11,500. Is this estimate over the top ???...
Looking to buy DVD's or Tape's of Home again. Are they available? I bought all the dvd's of Bob Vila show which came after Home Again, but I'm lo...
The bearings on this front loader are starting to become very noisy and need replacement. As usual, Kenmore does not sell a bearing & seal kit. The...
I just had my kitchen ceiling "repaired". The skim coated areas are not smooth. The ceiling has been primed and painted. I didn't see the poor wo...
We're remodeling our Seattle kitchen and would like to sell a full set of white metal Youngstown kitchen cabinets along with the sink unit & (newer...