Expert advice from Bob Vila, the most trusted name in home improvement, home remodeling, home repair, and DIY.

Bob's Bloggers

A community of bloggers who live and die to DIY

paint, furniture

How To: Paint Mahogany

By Alchemy Fine Living on Apr 15, 2013

I have painted a ton of furniture over the years and I have learned a lot through trial and error. Mahogany is always one of those woods that has given me a hard time. The first time I painted a mahogany dresser, the white paint I applied immediately turned bright pink. After several layers of paint, I’m talking at least six, it was still pink. I was totally baffled! Well, I have come a long way since then in my furniture painting knowledge and skills.

For a long time, I used shellac to stop the bleeding, which does the trick pretty well, but it is not the most economical. I recently discovered a product from Sherwin Williams that is a shellac based primmer -- and it is amazing! With shellac I usually found myself applying at least two layers before, then applying two layers of a top coat. With this pigmented primer it only took one coat and all stains were blocked. Not only did this product save me time, but it also used less material to achieve a gorgeous finish. The primer is a bit more expensive than most other primers, but not more expensive than buying and using shellac as a base coat.

How to paint mahogany white

1. Clean the furniture really well with TSP. If you are not familiar with TSP, Trisodium Phosphate, you can find it in the paint department at your local hardware store. It is used for preparing surfaces for paint.

2. Sand the surface with 220 grit sand paper, just enough to rough it up a bit. There is no need to remove the old finish. The shiny surface should just be dulled.

3. Remove all dust particles using a vacuum or forced air from an air compressor (this is especially helpful if the piece has a lot of carved details where dust has a tendency to stick).Then wipe with a damp cloth.

4. Applyone coat of Sherwin Williams white pigmented shellac primer.

5. Sand really well between coats of paint using 220 grit sandpaper.

6. Remove all dust once again.

7. Apply two layers of the top coat of your choice. I used Sherwin Williams Ivory Lace in a Satin finish.

Visit Alchemy Fine Living »

blog comments powered by Disqus