I have a Sear garage door opener that is about 12 years old. I replaced the batteries in the two openers for the cars. The openers now will not operate. Batteries are the same voltage. They will remember the codes for a bit but then seem to "forget" them. The opener on the outside of the garage which is also a wireless remote still works fine! Any ideas??
Thanks,
Mike
COMMUNITY FORUM
- Forum >
- Windows & Doors >
- Garage Door Openers Stopped Working
Hey Mike,
It is likely that you need to go ahead and reprogram your opener remotes. There is a button on the head/opener in your garage that you must push while simultaneously pushing the remote button: you must have the remote close to the opener head while doing this. This should fix your issue. Good luck.
It is likely that you need to go ahead and reprogram your opener remotes. There is a button on the head/opener in your garage that you must push while simultaneously pushing the remote button: you must have the remote close to the opener head while doing this. This should fix your issue. Good luck.
Yes I think the problem is that when you changed the batteries, it could have reset the programming inside that recognizes the signal from the remote. All you need is to reprogram the remote so that it cant connect with the doors again.
David
David
garage doors utilise the services of several reputable manufacturers, which enable us to install the garage door of your choice, colour and type be it; up and over, retractable, roller garage doors, sectional, side hinged or wrap around. Side doors or personal doors to match some garage doors are also available.
