The above description controls my ceiling fan and light.There
are only 2 wires coming into the switch control/one white one
black and i plugs into a small circuit board.
I went and bought a switch with three buttons/this switch
has 3 screw terminals.So the wall has two wires.Do I connect
the hot wire to the bot.screw and the ground wire to the ground side.Then make a jumper to connect the two remaining terminals on top? This would be fan to light with a hot wire.Will all the terminals be hot on the right side if I connect just one hot wire
to the bottom?will the above two be hot?
Get Help from Bob Vila
- Give-Aways & Offers
- Monthly Must Do's
- DIY Project Ideas
- Step-by-Step Guides
- Inspirational Photo Galleries