COMMUNITY FORUM

kickme

01:33PM | 05/27/04
Member Since: 05/26/04
3 lifetime posts
Bvwindows
Hello,

I just bought a steel door w/ frame.

I would like to install it in my basement

to make an entrance to my garage.

The wall is a hollow cinder block that is 3 and 5/8inches thick. But first I have to knock a hole in the wall.

The door frame height is 82inches tall and the ceiling is about 84 and 1/2 inches from the floor. leaving only 2 1/2 inches to work with.

I wanted to cement this door frame in place.

Does anyone have any helpful advice or tips?

I can't seem to find any info on this type of installation.

Is there a guide out there somewhere?

I don't want to use wood in the installation except to maybe temporary hold in place and not as headers or trimmer studs. Unless that is the norm, I don't know.

thanks

Jerry

kickme

08:33PM | 05/30/04
Member Since: 05/26/04
3 lifetime posts
It seems I'm alone on this one.

Well today I started cutting through

the cinder blocks and they are not hollow.

I used a circular saw

with a 7in masonary disc.

and I used my angle ginder alittle.

Boy what a lot of dust, no joke, my whole house has dust all over the place.

Warning for anyone attempting this it was pitch black in my basement.

I did use a plastic sheet to try to contain the dust but I did a bad job, really wasn't air tight. I definately paid the price for that. the wall is 3 5/8 inches thick so I could not cut through from one side. I had to cut from both sides cutting about 1 1/2 inch from each. I didn't finish cutting through all the way, it's difficult to a line the cut line from both sides of the wall, so I drilled plot holes and used some wood 1x3 7ft high,

securied to wall as guides.

Still didn't get the cut line the same on both sides, I'm pretty much disappointed.

I called it a day after 4hours or so.

I'll continue in a few days, not to **** my neighbors off, on account of the noise.

I'll update when I make so progress.

thanks for reading.

Jerry

PS I'm starting to think may be I should have got a professional to do this.

Not that it's super hard but it's a headache to clean and worried about the final outcome.

kickme

02:15PM | 06/02/04
Member Since: 05/26/04
3 lifetime posts
Well yesterday,

I finished knocking out the wall.

What I did was,

In my basement I made a containment unit,

something like a phone booth, it's made of 2 x 3's and plastic sheets, duct tape, staple gun. It worked great to contain the dust.

Then I used a new masonary disc 7in to continue to make the cuts deeper, since the first one I used had worn away to about 4inches.

I also used a chisel and hammer to help knock out the wall.

I bought a sleg hammer but didn't use it.

The top of the wall came out in the size of brick sections. (using a regular hammer)

The lower half came out as a whole piece.

There are small problems such as, some bricks got broken off too much and will need repairing. 1 came out completely.

I also messed up by cutting the bricks in certain areas way off on account of the dark dust, I couldn't see through it.

I'll continue when I get some needed rest and sleep.

Jerry

Now to dump the mess somewhere?
Click_to_reply_button
Inspiration_banner

INSPIRATION GALLERY



Post a reply as Anonymous

Photo must be in JPG, GIF or PNG format and less than 5MB.

Reply_choose_button

captcha
type the code from the image

Anonymous

Post_new_button or Login_button
Register

A simple banquette piled with pillows and lit from above with a wall sconce is a tempting spot to curl up with a favorite ... Built on a rocky island in the Drina River, near the town of Bajina Basta, Serbia, this wooden house was cobbled together ... Large steel-framed windows flood the interior of this remodeled Michigan barn with daylight. The owners hired Northworks A... Edging formed with upside-down wine bottles is a refreshing change. Cleverly and artistically involving recycled materials... A Washington State couple called on BC&J Architects to transform their 400-square-foot boathouse into a hub for family bea... Similar to the elevated utensil concept, hanging your pots and pans from a ceiling-mounted rack keeps them nearby and easy... For windows, doors, and mirrors that could use a little definition, the Naples Etched Glass Border adds a decorative flora... The thyme growing between these stepping stones adds a heady fragrance to strolls along this lush, low-maintenance garden ... Decoupage is an easy way to add any paper design to your switch plate, whether it is wallpaper, scrapbook paper, book page... Twine lanterns add pops of crafty—but sophisticated—flair to any outdoor setting. Wrap glue-soaked twine around a balloon ... When securely fastened to a tree or the ceiling of a porch, a pallet and some cushioning make the ideal place to lounge. V... Reluctant to throw away any of those unidentified keys in your junk drawer? Hang them from a few chains attached to a simp... A stripped-down model, sans screened porch, starts out at $79,000. Add the porch, a heated floor for the bath, and all the... Salvaged boards in varying widths and colors make up the dramatic accent wall in this attic space. The high-gloss white of... This garden shed has been decked out to the nines. Designer Orla Kiely created the intimate home for a flower trade show, ...
Follow_banner_a
Newsletter_icon Google_plus Facebook Twitter Pinterest Youtube Rss_icon
 
webapp1